X10 LM465 Install Manual

X10 Wireless Technology, Inc. Limited One Year Warranty

X10.com, a division of X10 Wireless Technology, Inc. (X10) warrants X10

products to be free from defective material and workmanship for a period of

one (1) year from the original date of purchase at retail. X10 agrees to repair

or replace, at its sole discretion, a defective X10 product if returned to X10

within the warranty period and with proof of purchase. If service is required

under this warranty:

Call 1-800-442-5065, visit www.x10.com, or e-mail support@x10.com.

For help or more information on setup, please visit:

http://www.x10.com/support

LM465-11/02

Check Out our Web site at:

http://www.x10.com

For more information on X10 products and

special promotional offers.

Setting The Module’s Code

Using a small screwdriver, set the red

House Code dial to the same letter as your

Controllers. Set the Black Unit Code dial to

any unused number.

3.

Plug the Module into

the same wall outlet as

your controller (see

testing below).

2.

Plug a lamp into

the Module.

1.

Set the House Code

and Unit Code.

Testing The Module

Make sure the lamp’s switch is on. Plug the Module into the same wall outlet as

your controller, press the On and Off buttons on the controller that correspond

to the Unit Code setting on the Module. If the Module turns on and off you can

unplug the Module or Controller and move it to its permanent location. If you

can’t control the module, visit http://www.x10.com/support for help.

Lamp Module  LM465

UNIT CODE

DIAL

HOUSE CODE

DIAL

Ratings

The Lamp Module can be used to control an incandescent lamp rated up to

300W. It is not suitable for other types of lamps such as fluorescent or energy

saving lamps, low voltage lamps, or lamps that include a dimmer control.

Caution: Do not connect an appliance such as a coffee pot or heater to a Lamp

Module. It may damage the Module and/or the appliance and could cause a fire

hazard. Use an Appliance Module instead.