X10 PalmPad HR12A Installation And Operating Instructions

X10 Wireless Technology, Inc. LIMITED 1-YEAR WARRANTY

X10.com, a division of X10 Wireless Technology, Inc. (X10) warrants X10 products to be

free from defective material and workmanship for a period of one (1) year from the original

date of purchase at retail. X10 agrees to repair or replace, at it’s sole discretion, a defective

X10 product if returned to X10 within the warranty period and with proof of purchase.

If service is required under this warranty:

1. Call 1-800-675-3044 or visit www.x10.com, or e-mail sales@x10.com to obtain a

Return Merchandise Authorization (RMA) number.

2. Return the defective unit postage prepaid to X10 (see address on back).

3. Enclose a check for $4.00 to cover postage and handling.

4. Enclose a dated proof of purchase.

5. X10 is not responsible for shipping damage. Units to be returned should be packed

carefully.

Please visit www.x10.com/warranty

to complete your on-line warranty registration. Thank you.

For help or more information on setup, please visit: www.x10.com/support

Installation and operating instructions for HR12A PalmPad

The HR12A PalmPad Remote Control sends Wireless Radio

Frequency (RF) signals to an X10 Transceiver (RR501 or TM751)

or any X10 security system base receiver. The receiver then passes

the signals onto your house wiring to control lights or appliances

around your home. You plug lights and appliances into X10

Modules (sold separately). The PalmPad also works with the

CM11A Two-Way Computer Interface to initiate macros (routines)

so you can set up a “coming home” routine which is initiated when

you press a button on the PalmPad.

1. Install 4 AAA alkaline batteries (sold separately) in the

PalmPad’s battery compartment.

2. Use a dime to set the Housecode dial to match the X10 Modules

and Transceiver you want to control.

3. Plug in an X10 Transceiver (RR501 or TM751, sold separately).

4. Set the Palm Pad’s slide switch to 1-8 to control X10 Modules

set to Unit Codes 1 thru 8.

5. Set the slide switch to 9-16 to control X10 Modules 9 thru 16.

6. Press the corresponding ON or OFF button to turn X10 Modules

on and off.

7. To brighten or dim lights connected to X10 Lamp Modules and

Wall Switch Modules, first press the corresponding number

button, then press the UP or DOWN (blue) buttons.

HR12A-9/01

F.C.C. CAUTION - 

THIS DEVICE COMPLIES WITH PART 15 OF THE

FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO

CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL

INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY

INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY

CAUSE UNDESIRED OPERATION. 

NOTE:

 NO CHANGES OR

MODIFICATIONS MAY BE MADE TO THE UNITS. ANY CHANGES

MADE TO THE UNITS WILL VOID THE USER'S AUTHORITY TO

OPERATE THE EQUIPMENT.