X10 XCam II ZB11A Operating Instructions
ZB10A
LIMITED 1-YEAR WARRANTY
X10.com, a division of X10 Wireless Technology, Inc. (X10) warrants X10
products to be free from defective material and workmanship for a period of one
(1) year from the original date of purchase at retail. X10 agrees to repair or
replace, at it’s sole discretion, a defective X10 product if returned to X10 within
the warranty period and with proof of purchase.
If service is required under this warranty:
1. Call 1-800-675-3044 or visit www.x10.com, or e-mail sales@x10.com to
obtain a Return Merchandise Authorization (RMA) number.
2. Return the defective unit postage prepaid to X10 (see address on back).
3. Enclose a check for $4.00 to cover postage and handling.
4. Enclose a dated proof of purchase.
5. X10 is not responsible for shipping damage. Units to be returned
should be packed carefully.
Please visit www.x10.com/warranty
to complete your on-line warranty registration. Thank you.
5
1. Open the lid on the base of the ZB10A battery pack.
2. Insert four AA alkaline batteries. Observe polarity.
●
Turns your XCam II into a PartyCam™
●
Lets you take your XCam II anywhere.
●
Uses four AA alkaline batteries.
●
Lasts for up to four hours.
Model ZB11A
ZB11A-09/01
XCam II Wireless cameras are normally powered from a small plug-in AC power supply. But with the new ZB10A battery
Pack you can now take your XCam II anywhere. Use it at parties, barbecues, or anywhere you like. The battery pack
accepts 4 AA alkaline batteries to give you 4 hours of fun.
XCam II Battery Pack
™
1
2
4
6
3
ZB10A
ZB10A
3. Pass the jack from the camera through the hole in the battery pack.
4. Coil the wire neatly inside, avoiding the screw bosses.
5. Screw the camera onto the battery pack, taking care not
to trap any wire.
6. Plug the jack from the battery
pack into the camera.
8. Turn the switch on the side of the ZB10A on. Turn off
when not in use (4 hour battery life). Refer to the setup and
operating instructions that came with the XCam II camera
system for camera setup and operation.
7. If the plug on your model of camera does not fit in the
jack on the ZB10A battery pack, plug the camera into the
ZA10A adapter (included) and then plug the adapter
into the battery pack.
ZB10A
ZB10A
ZA10A
7
Includes ZB10A
battery pack and
ZA10A adapter
For help or more information on setup,
please visit: www.x10.com/support