Xantech MS1 Installation Instructions

1

Emitters & Blasters

INSTALLATION INSTRUCTIONS

• The MS1 is a black (IR opaque) 1" x 2" shield that fits over both the Xantech Mouse Emitter shell and the

IR sensor window of a controlled component.  An optional accessory, it prevents unwanted external IR

signals from passing through it or leaking past it.

• The MS-1 also prevents IR from the Mouse Emitter from radiating backward into the IR sensors of other

components.

• It is especially useful for zone controlled applications where you want the equipment controlled only by

the Mouse Emitter fastened over the component IR sensors.

Install as follows:

1. Before removing the adhesive covers from the shield or the emitter, fit them together and temporarily

position them over the IR sensor window of the component.

2. When you have accurately determined the correct position for them, neatly trim the shield (if needed)

being sure that you leave sufficient material to overlap the extremities of the equipment’s IR sensor

window.

3. Remove adhesive covers from the shield and the emitter and stick them onto the IR sensor window.

MS1

MOUSE EMITTER SHIELD

Side View

Top View

Mouse

Emitter

Adhesive Layer

MS1

Mouse Emitter Shield

Controlled Component

MS1 and Mouse Emitter

 installed over IR sensor window. Trim

edges of MS1 as needed (see text).

Fig. 1 Using the MS1 Mouse Emitter Shield.

9-13-00