Summary of X-ONE
Page 1
Benutzerhandbuch owner’s manual x-one class d mono amplifier.
Page 2: Reference Note!
Table of content 13 14 15 17 17 18 19 21 22 very important advice for the installation and operation in newer vehicles! In vehicles with a newer year of manufacturing (since approx. 2002), normally computer controlled diagnosis- and controlling systems are applied - like can-bus or most-bus interfac...
Page 3
The purchased device is only suitable for an oper- ation with a 12v on-board electrical system of a vehicle. Otherwise fire hazard, risk of injury and electric shock consists. Please do not make any operation of the sound- system, which distract you from a safe driving. Do not make any procedures, w...
Page 4: Reference Note
Before you start with the installation of the sound system, disconnect by any means the ground connection wire from the battery, to avoid any risk of electric shock and short circuits. Reference note installation instructions 15 mechanical installation avoid any damage removing of the components of ...
Page 5: Reference Note
Installation instructions 16 installation of rca/audio signal cables and power supply. Attend while installation not to lead the audio cables between the headunit and the amplifier together with the power supply wires on the same side of the vehicle. The best is a areal separated installation in the...
Page 6
X- o n e 17 functions and operational controls 1 the master out / slave in rca jacks are suitable to connect an additional amplifier in master/slave mode. Attend therefor the chapter interconnection example: master/slave on page 19. 3 the bass boost controller adjusts the bass enhancement between 0d...
Page 7
X- o ne 18 interconnection • connect the rca lineouts of the headunit with the rca jacks line input of the amplifier with appropriate high-value rca cables. If your headunit is equipped with a additional subwoofer lineout (sub out), it is recommended to use this lineout. • connect the subwoofer with...
Page 8
X - o n e 19 interconnection master • connect the rca lineouts of the headunit with the rca jacks line input of the amplifier with appropriate high-value rca cables. If your headunit is equipped with a additional subwoofer lineout (sub out), it is recommended to use this lineout. • connect the remot...
Page 9
25 x - o n e 20 interconnection subwoofer • connect the subwoofer terminals with the speaker outputs (speaker output + / -) of both amplifiers by using appropriate wires. • always ensure the correct polarity of the speakers. The interchange of plus and minus cause total loss of bass playback and cou...
Page 10
25 26 specifications 21 models channels circuit output power rms 13,8 v watts @ 4 ohms watts @ 2 ohms watts @ 1 ohm output power max. 13,8 v watts @ 4 ohms watts @ 2 ohms watts @ 1 ohm damping factor signal-to-noise ratio thd&n input sensitivity input impedance filter operation mode lowpassfilter ba...
Page 11: Reference Note
Trouble shooting 22 protection circuit this amplifier owns a 3-way protection circuit. If overloading, overheating and shorted loudspeakers, or too low impedance or insufficient power supply is insisted, the amplifier shuts down to prevent serious damage. If one of this disfunctions is detected, the...
Page 12
Trouble shooting 23 malfunction: no function reason: remedy: 1. The power supply connection of the device is not correct. Recheck 2. The cabels have no mechanical or electrical contact. Recheck 3. The remote turn-on connection from the headunit to the amplifier is not correct. Recheck 4. Defective f...
Page 13: Car Audio Systems
Audio design gmbh · www.Audiodesign.De am breilingsweg 3 · d-76709 kronau (germany) tel. +49 (0)7253 - 9465-0 · fax +49 (0)7253 - 946510 car audio systems.