Xiamen RP80VI User Manual

Manual is about: Thermal Label Printer

Summary of RP80VI

  • Page 1

    1 thermal label printer rp80vi user manual.

  • Page 2

    2 content content..................................................................... ОШИБКА! ЗАКЛАДКА НЕ ОПРЕДЕЛЕНА. 1 . instruction ...................................................... ОШИБКА! ЗАКЛАДКА НЕ ОПРЕДЕЛЕНА. 1.1 safty warnings ..............................................................

  • Page 3

    3 10. The friver of the printer ..................... ОШИБКА! ЗАКЛАДКА НЕ ОПРЕДЕЛЕНА. 1. Instructions rp80vi series is thermal barcode printer with high performance and reliability. It is with high quality and competitive price and easy to use, so it is widely used in the factory, logistics, restaur...

  • Page 4

    4 (5) if long time not uses printers, should disconnect the adapter power. (6) don't disassemble the printer for overhaul or transformation. (7) please only use the adapter, which is together with printer (8) to ensure the quality and lifetime of printer, we recommend to use high-quality thermal pap...

  • Page 5

    5 3. Technical parameters ● printing method: direct thermal printing ● resolution: 203dpi ● printing width: 80mm ( max ) ● printing speed: 150mm/s (max); 127mm/s (normally) ● memory: dram: 8m flash: 4m ● interfaces usb interface: general usb interface (standard type b). Serial interface: db9 female ...

  • Page 6

    6 rp80vi-up: power port cash drawer parallel interface usb rp80vi-us: power port cash drawer serial interface usb rp80vi-use: power port cash drawer ethernet interface serial interface usb ● barcode: 1d code: code128 、 ean128 、 code39 、 code93 、 ean13 、 ean8 、 codabar 、 upca 、 upce 、 msi 、 msic 、 i2...

  • Page 7

    7 paper width: 16mm-82mm diameter of the outside paper roll: 85mm max paper-out method: automatically stripped or peeled off ● power adapter of the printer: adapter input voltage: ac 110v/220v , 50 〜 60hz adapter output voltage: dc 24v/2.5a printer input voltage: dc 24v/2.5a ● weight of the printer:...

  • Page 8

    8 printer power adapter power cord paper roll cd cable 4.2 the connection of the printer (1) make sure that the printer and pc are turned off, connect the cable to printer and the interface (serial/parallel/usb/ethernet) of the equipment. (2) if the automatic cash drawer is available, then connect t...

  • Page 9

    9 attention: (1) first plug the dc24v power cord of the printer, and then plug the ac220v power, at last turns the power switch. Do not do that opposite way, or it will do harm to the printer. (2) inappropriate use of the power adapter will lead to bad quality printing, or even do harm to the printe...

  • Page 10

    10 1. New printer 2. Change label 3. Printer initialization this function is for testing sensitivity of interval sensor. When users change paper of different specification or initialize printer, it needs to set up the interval sensor adjusting. Please follow up the steps below to adjust interval sen...

  • Page 11

    11 5.1 indicator s/n status function declaration 1 power light normally on, error light off normal 2 power light normally on, error light on error and refer to fault code 5.2 fault code code buzzer hint function 1 1 beep when printer is on initialization is finished 2 2 beep successively mechanism d...

  • Page 12

    12 save the parameters into memory.Finally,loosen pause button. 4 access debug mode 1.Close printer power. 2.Make sure printer feed paper,and then cover the upper cover. 3.Press on pause and feed buttons simultaneously,then open the power,when power light(blue) and error light(red) are on simultaneo...

  • Page 13

    13 gnd 5 5 gnd 6 dsr printer serial interface db9 4 dtr pos host serial interface db9 7. Printer parallel interface rp80vi printer parallel interface socket is 25pin parallel socket,8 bits parallel transmission,support busy/nack handshake protocol.Each pin function of printer parallel interface sock...

  • Page 14

    14 9. Printer cash drawer port the printer cash drawer port is with standard rj-11, 6-wires socket, output dc 24v/1a and work by power signal. Plug the rj-11 crystal plug into cash drawer port and then you can open the cash drawer via printer. Printer cash drawer interface pin functions are defined ...

  • Page 15

    15 no. Direction 1 empty empty 2 structure ground output 3 empty empty 4 cash drawer driver signal output 5 empty empty 6 empty empty 10 、 printer driver two types of drive for rp80vi series: one is to install driver program directly under windows9x/ me/ 2000 /xp, the other is to install drive throu...