Yamaha FX310A Owner's Manual
PRECAUTIONS
The output jack is an EIAJ-standard 1/4" phone jack. Be sure to use
an appropriate connection cable.
Always set the VOLUME control to “0” when plugging in or
unplugging the connection cable.
The battery check indicator (BATT.) will light briefly when a plug is
inserted or removed from the output jack. This is normal and does not
indicate a malfunction.
The built-in preamplifier is automatically turned on when a plug is
inserted into the output jack. When not using the instrument, or when
playing it without amplification, be sure to remove the plug from the
output jack so that the preamplifier power is turned off.
Also, even when the power is switched off, the system consumes a small
amount of power for the tuner standby mode. If the instrument is not
going to be used for an extended period of time, we recommend that the
battery be removed in order to avoid power consumption or leakage.
Owner’s Manual
Thank you for choosing a Yamaha electric-acoustic guitar.
In order to make the most of the advanced features and
performance provided by your guitar, please read this
manual carefully before using the instrument.
BATTERY REPLACEMENT
Be sure to replace the battery as soon as possible when the battery
check indicator lights in order to avoid reduced sound quality.
* Be sure to remove the battery if the instrument will not be used for an extended
period of time in order to prevent possible damage due to battery leakage.
* Always dispose batteries in accordance with local laws and regulations.
q Press the catch on the battery holder in the direction indicated by the arrow
in the illustration in order to unlock it.
w Slide out the battery case.
e Remove the old battery from the battery case, and insert the new battery making
sure that the (+) and (–) terminals of the battery are positioned as shown in the
illustration. Use only a DC9V, S-006P (6F22) or equivalent battery.
r Slide the battery case back into the battery holder and press firmly so
that the battery case locks into place.
ELECTRIC
ACOUSTIC GUITAR
NOMENCLATURE/THE CONTROLS
SPECIFICATIONS
System
SYSTEM-57: Monaural 3 way
Pickup
Contact Pickup (installed inside of the body)
Pre-amplifier Controls
MASTER VOL., 3 Band (HIGH, MID, LOW)
EQ control, SUB PICKUP MIX control
(TREBLE SIDE, BASS SIDE)
Output jack
Combination end pin/power switch
Output impedance
1 k
Ω
Power supply
9V DC, S-006P (6F22) dry cell battery
Battery life
Approx. 60 hours (without tuner)
Approx. 57 hours (with the preamp
switched ON and the tuner used 1 minute
every 1 hour)
* When using a manganese battery.
* Varies according to operating conditions.
Tuner
Tuning System: Chromatic type (12
semitones), A4=440Hz
Auto OFF Function: Tuner automatically
switches OFF after 2 minutes.
Input: Built in pickup
Accuracy: +/– 3 cents
Accessories
• Hexagonal wrench for neck adjustment x1
• S-006P (6F22) dry cell battery x1
•
Sound hole cover
x1
USING THE TUNER
The guitar is equipped with an A4=440Hz standard pitch tuner. The
tuner’s circuitry is independent from the guitar’s output circuit so
switching the tuner ON/OFF will have no affect on sound output.
q
Press the TUNER switch. While the tuner activates the
and
lamps
light alternately.
w
Tune the guitar string until the note name of the desired pitch appears in
the tuner’s display.
The
lamp indicates the pitch is low.
The
lamp indicates the pitch is high.
The pitch indicator (
) flashes slower as the string’s pitch nears the
note shown in the display.
e
The string is in tune when the
and
lamps both light.
r
Holding the TUNER switch down turns the tuner OFF.
* The tuner will automatically switch OFF approximately two minutes after the
TUNER switch is pressed (energy saving function). To continue tuning, press
the TUNER switch again.
* It may take a few seconds before the tuner can detect pitches after being switched ON.
* The note name and
displays may have difficulty keeping up with irregular
pitch changes. Gradually change the pitch and check when tuning.
* The tuner may have difficulty detecting notes rich with overtones or with very
short sustain.
q MASTER VOL. (Master Volume) Control
Adjusts the overall output volume level.
* Make sure that the VOL. is turned to “0” before connecting or disconnecting.
w BATT. (Battery Check) Indicator
This indicator will light when the battery needs to be replaced. Please
replace the battery as soon as possible when the BATT. indicator lights.
e 3 Band Equalizer
LOW : Boosts or cuts the level of the low frequencies.
MID
: Boosts or cuts the level of the middle frequencies.
HIGH : Boosts or cuts the level of the high frequencies.
r SUB PICKUP MIX Control
Mixing output of the main and sub pickups allows greater sound creating
capabilities.
TREBLE : Controls the volume of the treble side sub pickup.
BASS
: Controls the volume of the bass side sub pickup.
t
Tuner Switch
Switches the tuner ON/OFF.
y
Tuner Display
Displays tuner information.
USING THE SOUND HOLE COVER
Feedback often occurs when controls are boosted on the electric acoustic
guitar to match the volume of other instruments when playing in a band.
When the instrument is used under the conditions described above, the
Sound Hole Cover should be inserted into the sound hole.
With the Sound Hole Cover in place, feedback is effectively reduced.
Battery Holder
Control Section
Output Jack (with power switch function)
Sound Hole Cover
(Accessory)
Pickup
OPEN
Catch
DC9V S-006P
(6F22)
Battery case
q
OPEN
w, r
e
w
r
q
w
e
y
t
r
–12
+12
HIGH
BATT.
TUNER
SUB PICKUP MIX
BASS SIDE
TREBLE SIDE
–12
+12
MID
MASTER
VOL.
LOW
0
10
0
10
0
10
q MASTER VOL.
Main Pickup
Bass Side
Sub Pickup
Mix of Bass Side
Sub Pickup
Treble Side
Sub Pickup
Mix of Treble
Side Sub Pickup
system57̲ws66420̲R1.pm65
11.8.8, 3:53 PM
Page 2
Adobe PageMaker 6.5J/PPC