Zee Z-3020 Installation Manual And User's Manual

Summary of Z-3020

  • Page 1

    1 z-3020 installation guide and user manual.

  • Page 2

    2 iveda z-3020 installation guide and user manual please use this guide to set up your z-3020 ip camera package contents check the package contents against the list below. Camera z-3020 ip camera software cd installation guide and user manual mounting bracket (3) screws, (3) plastic wall anchors, an...

  • Page 3

    3 led indicator definition led color indication network blue flash blue during network activity power red steady red for booting up process; steady red 30 seconds when wps configure blue steady blue for booting up completion purple flash purple then steady red during firmware upgrading; or when wire...

  • Page 4

    4 install the hardware and connect all cables wall mounting and ceiling mounting 1. Use the 3 supplied screws to fix the base plate to a flat surface. 2. Loosen the lock ring to adjust the desired angle of the camera. 3. Tighten the lock ring. Connect cables and power supply 1. Connect the power ada...

  • Page 5

    5 adding your camera 1. Connect ip camera to network router via network cable. 2. Power on ip camera. Please also ensure your router’s dhcp is activated. 3. Visit the hosting url of your service provider given when you purchased your camera. 4. If you do not have an account, click on “create account...

  • Page 6

    6 7. If no cameras have been added, you will be prompted to add a camera. Otherwise, click “settings” at the bottom of the page. 8. Clicking will pop up a reminder to ensure the ip camera you are going to bind has already been connected to the network properly. Then follow the binding method via bro...

  • Page 7

    7 9. A table will then display for filling in the ip camera’s mac address and activation code after clicking “next”. Click “apply” when finished providing required information. Cameras can also be added by using the smart phone app provided by your service provider. 10. “success” shows when finished...

  • Page 8

    8 clicking on the “share” button at the bottom of the screen will show all cameras that belong to other accounts that are shared with your account. 13. Watching your cameras click the “matrix” at the bottom of the page and you will view the cameras in rtsp streaming..

  • Page 9

    9 basic functions tool bar the tool bar is located in the upper right hand side of each ip cam view for easy management. 1. Lights indicators green light the green light means the ip camera is online and streaming video, therefore its video is successfully displayed on the screen. Yellow light the y...

  • Page 10

    10 you may also choose to mute the camera by clicking the button. When the video does not display well, you can click to reload the media again. You can access the camera’s control ui by clicking the button. The “camera list” with the arrow buttons and is displayed on the left-hand side of the scree...

  • Page 11

    11 the detailed recording clips will be displayed when you mouse over the orange tags. You can select the specific clip to review. 3. Settings the settings button will take you to that specific ip camera’s web user interface. 4. Mute the mute or un-mute buttons are used to control whether the users ...

  • Page 12

    12 wireless settings after logging into the camera user interface using the user login click on basic setting, and then go to the wlan section on the right. Make sure wlan is enabled and select the appropriate ssid for your network. Important note: 1. Please plug in the antenna inside the box 2. You...

  • Page 13

    13.