1B PARAGON Use And Care Manual - Cleaning Paragon Probe
Cleaning Paragon Probe
Charging Paragon Probe
There is a low battery indicator that will illuminate
when the battery has 15% capacity remaining .
To charge, insert the micro USB cord (included
within the box) into the bottom of the Paragon
Probe and then insert the other end into a USB port
or 5 volt wall adapter* to charge.
It is recommended to allow the probe to charge for
at least 4 hours. Fully charged, the battery will last
~40 hours. If you are performing a long term cook
of more than 40 hours using the probe, it can be
plugged in and charging while in use to prevent
interruptions in the cook cycle.
*5 volt wall adapter not included.
Turn off the probe before cleaning.
Gently wipe it down with a damp cloth and a
mild soap. Do not submerge the black and grey
plastic section in water at any time.
8
CAUTION:
The Paragon Probe is
water resistant, but not water tight.
DO NOT
put it in the dishwasher to clean or submerge
the electronics portion underwater.
Electronics are located within
the hard plastic body.
Micro USB is located on the
bottom of the probe.
C
ARE
AND
CLEANING:
The
Paragon
Probe