21st Century Alarms LuxHome User Manual - Century Alarms
Security House, 107 Sandwich Close, Blackburn, Lancashire BB1 1PU
01254 265052 0775 1360143 peter@21stcenturyalarms.co.uk
21
st
Century Alarms
Alarm & CCTV Solutions
www.21stcenturyalarms.co.uk
Intruder Alarms: Wired & Wireless
Alarm Central Monitoring
Commercial & Domestic CCTV
Alarm Service, Upgrades and Repairs
Auto Dialler
Once the Call from the Alarm’s Auto Dialler has been received:
During or after the message is played, Press
“*”
on your phones keypad to acknowledge
the call and stop the Auto Dialler dialling numbers 2 and 3.
The Auto-dialler with respond with a Tone and then hang up.
Reset Alarm Following Activation
Following an Activation of the Alarm, Disarm as normal, the control Panel will display the
Zone that has been triggered. (Flashing LED over the Zone Number).
Press:
To reset Alarm and Clear Display (display reverts to normal after 5 minutes)
Changing the User Code
1. Enter Programming mode, as detailed below.
The Arm and Part-Arm LEDs will illuminate and all Zone, Fire and tamper LEDs will flash.
The system is now in Programme Mode.
2.
Zone LEDs 1-4 will illuminate.
3. Enter a new 4 digit User Access code. As each digit is entered an illuminated zone LED
will be turned OFF.
4.