2gig Technologies HD100 Quick Manual - page 2
IMPORTANT SAFETY INSTRUCTIONS
1
Do not install this device near water.
2
Do not install near any heat sources such as radiators, heat registers,
stoves, or other apparatus (including amplifiers) that produce heat.
3
Only use attachments and accessories specified by 2GIG Technologies.
4
Protect the power cord from being walked on or pinched particularly
at the point where it exits from the device. (See figure below)
REGULATORY INFORMATION
This device complies with Part 15 of the FCC's Rules. Operation is subject
to the following two conditions:
1
This device may not cause harmful interference, and
2
This device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more
of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
This product complies with FCC radiation exposure limits for an
uncontrolled environment. Avoid operating this product at a distance less
than 20 cm from the user.
Caution: Any changed or modifications not expressly approved by the
party responsible for compliance could void the user's authority to
operate this equipment.
IC approval
This device complies with Industry Canada license‐exempt RSS
standard(s). Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation
of the device.
RÉGLEMENTATION IC: Cet appareil est conforme avec Industrie Canada
exempts de license standard RSS (s). L'opération est soumise aux deux
conditions suivantes: (1) cet appareil ne peut causer d'interférences, et
(2) cet appareil doit accepter toute interférence, y compris les
interférences qui peuvent causer un mauvais fonctionnement du
l'appareil.
Cet équipement est conforme aux limites IC exposition au rayonnement
pour un environnement non contrôlé. Cet équipement doit être installé et
utilisé avec distance minimum de 20cm entre l'utilisateur et l'élément
rayonnant de l'appareil.
Remarque: le fabricant n'est pas responsable des interférences radio ou
télévision causé par des modifications non autorisées de cet équipement.
Une telle modification pourrait annuler l'autorité de l'utilisateur
d'exploiter cet équipement.
This Class B digital apparatus complies with Canadian ICES‐003
Cet appareil numérique de classe B est conforme Ia á norme NMB‐003 du
Canada.
LIMITED WARRANTY
This 2GIG Technologies product is warranted against defects in material
and workmanship for 1 year. This warranty extends only to wholesale
customers who buy direct from 2GIG Technologies or through 2GIG
Technologies’ normal distribution channels. 2GIG Technologies does not
warrant this product to consumers. Consumers should inquire from their
selling dealer as to the nature of the dealer’s warranty, if any.
There are no obligations or liabilities on the part of 2GIG Technologies for
consequential damages arising out of or in connection with use or
performance of this product or other indirect damages with respect to
loss of property, revenue, or profit, or cost of removal, installation, or
reinstallation. All implied warranties for functionality, are valid only until
the warranty expires. This 2GIG Technologies Warranty is in lieu of all
other warranties expressed or implied.
All products returned for warranty service require a Return Product
Authorization Number (RPA#). Contact 2GIG Technologies at 1(866)670‐
1591 for an RPA# and other important details.
Warranty service return address:
2GIG Technologies, Inc.
2961 W Maple Loop Drive
Lehi, Utah 84043
Technical Support Contact Information
Toll Free: 1(855) 244-4832
Email: techsupport @2gig.com
Internet: dealer.2gig.com
PN: 77‐100001‐001 Rev. F