3Com 10G Installation Manual

Page of 4

Download

Bookmark us

3Com Switch 4200G

10G Interface Module

Installation Guide

1. XFP Interface Module

1.1 Appearance and front panel

Figure 1 Appearance of an XFP interface module

Figure 2 Front panel an XFP interface module

1.2 Installation

Step 1: Put on an ESD-preventive wrist strap and verify it is properly

grounded. Then remove the XFP interface module from the package.

Step 2: Loosen the filler panel mounting screws on the rear panel of the

switch with a screwdriver and remove the filler panel.

Step 3: Hold the fastening screws on the front panel of the XFP interface

module, and gently push the module in along the slot guide rail until the

module is in close contact with the switch.

Step 4: Tighten the fastening screws with a screwdriver to secure the XFP

interface module.

Page 1
1 3com switch 4200g 10g interface module installation guide 1. Xfp interface module 1.1 appearance and front panel figure 1 appearance of an xfp interface module figure 2 front panel an xfp interface module 1.2 installation step 1: put on an esd-preventive wrist strap and verify it is properly groun...
Page 2: 1.3 Removal
2 (1) (2) (4) (3) (1) (2) (4) (3) (1): switch (2): optional module slot (3): xfp interface module (4): push-in direction figure 3 installing an xfp interface module note: (1) store the filler panel for future use. (2) when tightening the fastening screws at both sides of the optional module with a s...
Page 3: 2. Xenpak Optical Module
3 2. Xenpak optical module 2.1 appearance and front panel figure 4 appearance of a xenpak optical module figure 5 front panel of a xenpak optical module 2.2 installation step 1: put on an esd-preventive wrist strap and verify it is properly grounded. Then remove the xenpak optical module from the pa...
Page 4: 2.3 Removal
4 (1): switch (2): filler panels for optional module slots (3): small cover plate (removed) in the middle on the filler panel (4): push-in direction (5): xenpak optical module figure 6 installing a xenpak optical module note: (1) retain the small cover plate for future use. (2) do not tighten the mo...