3Com 3C17700 - SuperStack 3 Switch 4900 Getting Started Manual - page 31
Manual is about: Getting Started Guide
of
82
Switch 4950 — GBIC Operation
31
Figure 11 Inserting a GBIC Transceiver into a Switch 4950
3 The transceiver connects to the network using a duplex SC connector.
Attach a male duplex SC connector on the network cable into the duplex
SC connector on the transceiver.
4 Connect the other end of the cable to a device fitted with an appropriate
Gigabit Ethernet connection.
5 Check the LEDs on the front of the Switch to ensure that it is operating
correctly. Refer to
“LEDs”
on
page 17
for more information.
Removing a GBIC
Transceiver
If you wish to remove the transceiver, compress the side tabs and gently
pull the transceiver out of the port.