3Com 3C6090 - NETBuilder II Dual Processor Engine Router User Manual - page 13
Manual is about: User Guide
of
34
Installing Software
1-7
3 Verify that configurable parameters of your console match the configuration
settings of the Console port specified in Table 1-1.
4 Turn on the console.
Installing Software
If you have the software from 3Com preinstalled on a flash memory card,
remove the flash memory drive cover if present and insert the card into drive A,
the top flash memory drive. The default boot and configuration file paths are
set to a directory on drive A.
See the next section to remove and reinstall the flash memory drive cover.
Table 1-1 Console Port Configuration Settings
Characteristic
Setting
Baud rate
9600
Databits
8
Parity
None
Stop bits
1
DTR
Ignored
Duplex
Full
Echo
Off
Flow control
X-on/X-off