3Com 3CNJ100 - IntelliJack Switch Installation Manual - page 20
Manual is about: 3Com Installation Guide 4-port 10/100 Mbps Unmanaged Ethernet Switch 3CNJ100
of
42
Installation Guide
16
2
Thread the network cable(s) through the empty slot on the
Network Jack.
3
Terminate the end of the network cable(s) with the
connector(s) you purchased separately.
Refer to the connector manufacturer’s instructions for
terminating the cable. Be sure to test end-to-end system
functionality and verify that it is working.
4
Snap the connector(s) into the appropriate adapter plate.
Each adapter plate is labeled with the name of a connector’s
manufacturer. Be sure to use the adapter plate that matches
the manufacturer of your connector(s).
5
Mount the adapter plate to the Network Jack using the two
adapter plate screws provided.
Wall
To wiring
closet