O ffice c onnect w ireless 54m bps 11 g t ravel r outer 3crtrv10075/wl-534 w ireless a ccess p oint • r outer • w ireless c lient b ridge q uick s tart g uide introduction please take a few minutes to familiarize yourself with the features and functions of your new 3com officeconnect wireless 54mbps...
2 modes your 3com officeconnect wireless 54mbps 11g travel router has four modes: ■ setup/configuration mode — used for configuration only. ■ ap (access point) mode. ■ router mode ■ client mode — allows a device with an ethernet port to connect to a wireless network. The mode is set only by the mode...
3 you can connect to the travel router using either the wireless interface or the wired ethernet connection. See the later section initial configuration for details. Router mode in router mode, the travel router acts as a dhcp server, allocating ip addresses for wireless stations (clients). It also ...
4 common services such as http, ftp, e-mail, etc.) if you have problems, you should try getting permission for all users to connect to the lan/wan, so you can use ap mode instead. You can connect to the travel router, and change its configuration, while it is router mode. The ip address used is the ...
5 when should i not use access point (ap) mode? Do not use ap mode in this situation: ■ you do not have permission for all of these users to connect to the lan or wan on the ethernet port. In this situation, you should use router mode. Client mode in client mode, the travel router is connected to th...
6 ■ wireless — select the wireless network with the 3com ssid (3com is the default ssid). 4 start your web browser. 5 in the location or address bar, enter the following: config.Ap this will work only while in setup/configuration mode. In ap mode, you cannot connect. In router mode, you must connect...
7 using router mode to use routing mode: 1 use a standard lan cable to connect the ethernet port to the desired lan or wan port. There is a potential problem if you change the lan/wan connection from the travel router to your pc, or vice versa. Some cable modems can be locked to the mac address of t...
8 an on-line help is accompanied in each configuration page to assist you in setting up or configuring the travel router: 5 check the ethernet (wan) port status and settings. ■ if the travel router has not obtained a valid ip address, click the configure button and change the settings as required. C...
9 6 you should then be able to connect to the lan via the travel router. ■ you can check the status of your pc's wireless interface to see that your pc has obtained an ip address. ■ note that this ip address must come from a dhcp server on the lan; the travel router itself is transparent and does no...
10 regulatory compliance notices note: this product contains encryption. It is unlawful to export out of the u.S. Without obtaining a u.S. Export license. Fcc part 15 notice (applicable to use within the usa) caution: fcc radio-frequency exposure notice this device generates and radiates radio-frequ...
11 industry canada notice (applicable for use within canada) this device complies with canadian rss-210. To prevent radio interference to the licensed service, this device is intended to be operated indoors and away from windows to provide maximum shielding. Equipment (or its transmit antenna) that ...
12 3com corporation 350 campus drive, marlborough, ma 01752-3064 copyright © 2004, 3com corporation. All rights reserved. No part of this documentation may be reproduced in any form or by any means or used to make any derivative work (such as translation, transformation, or adaptation) without writt...
