1. DL manuals
  2. 3Com
  3. Wireless Access Point
  4. 3CRWX275075A
  5. Quick Start Manual

3Com 3CRWX275075A Quick Start Manual

Summary of 3CRWX275075A

  • Page 1

    Quick start guide ap2750 managed access point 3crwx275075a the 3com ap2750 managed access point provides ieee 802.11a or 802.11b/g wireless access to the network. The access point is designed for use with a 3com wireless lan switch, and requires hardware installation only. All configuration for the ...

  • Page 2

    3com ap2750 managed access point features feature description power port the access point can be powered either via power over ethernet (poe), or by an external power supply (not included) that is plugged into the power port. Serial port the serial port is not supported. Ethernet port the ethernet p...

  • Page 3: Observing Safety Precautions

    Observing safety precautions this equipment must be installed in compliance with local and national building codes, regulatory restrictions, and fcc rules. For the safety of people and equipment, only professional network personnel should install the access point. 1 unpacking the access point make s...

  • Page 4: Attaching The Antennas

    3 attaching the antennas carefully unpack the standard detachable antennas. Screw the antennas on to the antenna connectors on the access point and hand-tighten them. After network startup, you may need to adjust the antennas to fine-tune coverage in your area. For best results, adjust the antennas ...

  • Page 5: Mounting The Access Point

    4 mounting the access point the access point can be mounted on the following types of surfaces: • wall, ceiling, or electrical box (nema enclosure) • tabletop . Wall, ceiling, or electrical box mounting to mount the access point to a wall, ceiling, or electrical box: 1 remove the access point from t...

  • Page 6

    The figures below show the mounting bracket being mounted to a wall, and then a cable being routed through the large opening on the back of the mounting bracket. 4 connect the ethernet cable (and power cable, if applicable) to the port(s) on the front of the access point. 5 snap the access point ont...

  • Page 7: Tabletop Mounting

    Tabletop mounting to install the access point on a flat surface such as a table or desktop: 1 remove the backing from the four rubber feet and attach them on the bottom of the mounting bracket that is attached to the access point. 2 place the access point on the table. 3 connect the ethernet cable (...

  • Page 8: Checking The Led Indicators

    Copyright © 2006 3com corporation. All rights reserved. 3com and the 3com logo are registered trademarks of 3com corporation. All other company and product names may be trademarks of the respective companies with which they are associated. Part number 10015413 rev. Aa published july 2006 6 checking ...