- DL manuals
- 3Com
- Wireless Access Point
- 3CRWX385075A - Wireless LAN Managed Access Point 3850
- Quick Installation Manual
3Com 3CRWX385075A - Wireless LAN Managed Access Point 3850 Quick Installation Manual
Summary of 3CRWX385075A - Wireless LAN Managed Access Point 3850
Page 1
3com ® wlan managed access point ap3850 quick installation guide 3crwx385075a model ap3850 www.3com.Com part no. 1001633 rev. Aa published september 2007.
Page 2
3com corporation 350 campus drive marlborough, ma usa 01752-3064 copyright © 2007, 3com corporation. All rights reserved. No part of this documentation may be reproduced in any form or by any means or used to make any derivative work (such as translation, transformation, or adaptation) without writt...
Page 3
Installing a 3com™ wlan managed access point (ap3850)™ this document provides basic hardware installation instructions for the ap3850. For more information about installing your ap3850, as well as safety and installation requirements, see the following: • 3com wlan managed access point ap3850 instal...
Page 4
Warning! Installation must be performed by qualified service personnel only. Read and follow all warning notices and instructions marked on the product or included in the documentation. Before installing the product, read the rest of this document. Waarschuwing! De installatie mag alleen worden uitg...
Page 5
Varoitus! Installatie dient uitsluitend plaats te vinden door bevoegde monteurs. Lees alle waarschuwingen en instructies die op het product zijn aangegeven of in de documentatie zijn opgenomen, en volg deze op. Lees voordat u het product installeert eerst de rest van dit document. Viðvörun! Aðeins h...
Page 6
Cable requirement the ethernet ports on a ap3850 cannot accept a cat 5 cable that has an uneven sheath such as the one shown in figure 0-1. The rj-45 connector on the cable will not seat properly in the receptacle on the ap3850. Use a cat 5 cable with an even sheath instead. Figure 0-1 do not use a ...
Page 7
1 use the mounting template to cut a hole for the cat 5 cable. 2 remove the mounting bracket from the ap3850. 3 attach the mounting bracket to the t-bar clamp. 4 insert the cat 5 cable through the port connector opening in the mounting bracket, then plug the cable into the ap3850. 840-9502-0011 840-...
Page 8
5 attach the ap3850 to the mounting bracket. Suspended ceiling installation—drop ceiling tiles this procedure applies to t-bars that are 23.9 mm (15/16 inches), 14.2-mm (9/16-inches), or 15.9-mm (5/8-inches) wide. You also can use this procedure for flush ceilings with 14.2-mm (9/16-inch) or 15.9-mm...
Page 9
840-9502-0011 840-9502-0008 t- bar t-bar clamps (attached to t-bar) universal mounting bracket 840-9502-0012 (viewed from above ceiling tiles, looking down.) port connector opening t-bar universal mounting bracket 840-9502-0004 port connector opening 840-9502-0002.
Page 10
6 attach the ap3850 to the mounting bracket. 840-9502-0006 lock t-bar.
Page 11
Junction box installation 1 remove the mounting bracket from the ap3850. 2 attach the bracket to the junction box. 3 plug the cat 5 cable into the ap3850 and attach the ap3850 to the mounting bracket. Mounting hardware mounting bracket mobility point 840-9502-0090 840-9502-0011 840-9502-0008 840-950...
Page 12
Solid wall or ceiling installation 1 use the mounting template to cut a hole for the cat 5 cable. 2 remove the mounting bracket from the ap3850. 3 attach the bracket to the wall or ceiling. 4 plug the cat 5 cable into the ap3850 and attach the ap3850 to the mounting bracket. Tabletop installation 1 ...
Page 13
840-9502-0016 universal mounting bracket cable lock rubber feet mounting bracket mobility point 840-9502-0092 840-9502-0011 840-9502-0008.
Page 14
2 reverse the bracket and reattach it to the ap3850. 3 attach the rubber feet. 4 turn the ap3850 over and place it on the table. Configuring the ap3850 to configure the channels, power settings, and other ap3850 parameters, see the following: ■ 3com mobility system software quick start guide ■ “conf...
Page 15
Regulatory information the 3com wlan managed ap3850, model ap3850 (3crwx385075a) must be installed and used in strict accordance with the manufacturer’s instructions as described in the user documentation that comes with the product. This product contains encryption. It is unlawful to export out of ...
Page 16
Us – radio frequency requirements this device must not be co-located or operated in conjunction with any other antenna or transmitter. This device is for indoor use only when using channels 36, 40, 44 or 48 in the 5.15 to 5.25 ghz frequency range. High power radars are allocated as primary users of ...
Page 17
Declares that the product: brand name: 3com corporation model number: ap3850 equipment type: wlan managed access point ap3850 complies with part 15 of the fcc rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must acc...
Page 18
Industry canada – emissions compliance statement this class b digital apparatus complies with canadian ices-003. Avis de conformité à la réglementation d’industrie canada cet appareil numérique de la classe b est conform à la norme nmb-003 du canada. Safety compliance notice this device has been tes...
Page 19
Note: to ensure product operation is in compliance with local regulations, select the country in which the product is installed a copy of the signed declaration of conformity can be downloaded from the product support web page for the 3com managed ap3850, model ap3850 (3crwx385075a) at http://www.3c...
Page 20
Eu – restrictions for use in the 2.4ghz band this device may be operated indoors or outdoors in all countries of the european community using the 2.4ghz band: channels 1 – 13, except where noted below. ■ in italy the end-user must apply for a license from the national spectrum authority to operate t...