3Com IntelliJack NJ200 User Manual - page 16
Other manuals for IntelliJack NJ200:
Software Manual, Supplementary Manual
Manual is about: 3Com IntelliJack NJ200: User Guide
of
58
12
C
HAPTER
1: I
NSTALLING
THE
NJ200 N
ETWORK
J
ACK
supply from 3Com (see “Obtaining Optional Components” on page 4). To
connect the local power supply to the Network Jack, please follow these steps:
1 Route the power cable through the strain relief of the Network Jack (as shown in
the diagram below).
2 Securely mount the Network Jack on a wall.
3 Plug the power cable into the Network Jack.
4 Secure the local power supply and cable to the wall.
5 Plug the local power supply into the power source.
WARNING: Use the local power supply available from 3Com. Failure to do so
may result in damage to the Network Jack, or may result in a hazardous
situation.