3Com OfficeConnect 3C612 Quick Start Manual

Manual is about: 3Com OfficeConnect 3C612: Quick Start

Summary of OfficeConnect 3C612

  • Page 1

    Officeconnect ® remote 612 adsl router (3c612) quick start guide english.

  • Page 2

    3com corporation 5400 bayfront plaza santa clara, california 95052-8145 copyright © 2001 3com corporation. All rights reserved. No part of this documentation may be reproduced in any form or by any means or used to make any derivative work (such as translation, transformation, or adaptation) without...

  • Page 3

    Unpack the contents of your package, and ensure that it includes the following items: • ac/dc power adapter • lan (ethernet) cable, rj-45/rj-45 (cat-5) • adsl cable, rj-11/rj-11 • rubber feet (4) congratulations on choosing the 3com ® officeconnect ® remote 612 adsl router, your adsl (asymmetric dig...

  • Page 4

    Dhcp: (dynamic host configuration protocol): dynamic ip addressing is the type of addressing scheme most often used by internet service providers (isps), and is also the type that is preva- lent in many existing corporate networks. The officeconnect remote 612 adsl router, which can act as a dhcp se...

  • Page 5

    The following illustration (fig. 1) shows the connector cabling and the locations of the reset button and the pc/hub switch for the officeconnect remote 612 adsl router: as part of the installation procedure on the following pages, you will perform the following steps: 1. Connect the dsl cable. Conn...

  • Page 6

    3. Setup summary this screen relates a summary of the installation settings you selected. If you need to make changes, click back to step back through the previous screens. Otherwise, click next. The necessary files are now being copied to your pc. 2. Choose installation location the setup wizard pr...

  • Page 7

    5 4. Connect the dsl cable connect the dsl cable to the adsl wall jack and the other end to the dsl port of your officeconnect remote 612 adsl router. Click next. Figure 5 figure 6 figure 7 installation procedure cont’d 5. Connect the power adapter connect the cable from the power adapter to the pow...

  • Page 8

    10. Verifying the connection after the computer has rebooted, you will be presented with the screen shown in figure 9. Click next to start the verification process for your router. This ensures that your pc can communicate properly with your router. If there is an error, follow the on-screen prompts...

  • Page 9

    7 the system will launch your browser and take you through a couple of con- figuration screens, shown in figure 11a and 11b, to set up your internet connection information. Your isp will provide you with the information necessary to complete the internet connection screen. When you see the screen sh...

  • Page 10

    8 restarting the officeconnect remote 612 adsl router: to restart the officeconnect remote 612, use the restart/restore section in the advanced menu in the user manager. Restoring factory default settings: to reset the router to the factory default settings, disconnect the ethernet cable and then pr...

  • Page 11

    Lan led is off the ethernet cable may not be connected or be damaged. Make sure that the ethernet cable is properly plugged in, or replace it with another ethernet cable. Pc/hub switch is not set correctly. The switch should be “in” if the router is connected to a pc; and it should be “out” if the r...

  • Page 12

    Why can’t i browse the internet from my computer? There are many possible reasons why this could happen. Follow the steps below to try and identify what may be causing the problem. 1) check the leds on the front of the router. The power, lan and adsl leds should be green (and may be flashing). When ...

  • Page 13

    11 the led indicators on the front panel of the officeconnect remote 612 adsl router (fig. 14) provide the following information: front panel indicators power off power not being supplied to the unit. Green remains lit as long as power is supplied to the unit. Alert off the router is operating prope...

  • Page 14

    Information contained in this document is correct at time of publication. The following services are available 24 hours a day, 7 days a week. For the most up–to–date information, 3com recom- mends that you access the 3com corporation world wide web site. World wide web site http://www.3com.Com this ...

  • Page 15

    13 returning products for repair before you send a product directly to 3com for repair, you must first obtain a return materials authorization (rma) number. Products sent to 3com without rma numbers will be returned to the sender unopened, at the sender’s expense. To obtain an rma number, please cal...

  • Page 16

    3com corporation, corporate headquarters, 5400 bayfront plaza, santa clara, ca 95052-8145, usa. To learn more about 3com solutions, visit www.3com.Com. 3com corporation is publicly traded on nasdaq under the symbol coms. All specifications are subject to change without notice. Printed in ireland. Pa...