3Com PC Card User Manual - page 35

AT Commands

31

W: Connection Result Codes

Defines the type of (extended) negotiation result codes to return.

X: Result Code Set/Call Progress

Z: Recall User Configuration

W0 

Negotiation codes not reported.

W1

Negotiation codes reported in 3 line format (Hayes format).

W2 

Negotiation codes reported in 1 line format (Microcom format).

W3 

Negotiation codes reported in 1 line format (Microcom format). The 

receive and transmit bit rates will be displayed, Rx/Tx bit rates.

X0

Causes the modem to ignore any network tones and omit the connection 

speed message. 

X1 

As above but enables the connection speed result codes.

X2 

Causes the modem to detect dial tone.

X3 

Causes the modem to detect busy tone.

X4 

Causes the modem to detect busy and dial tones.

X5 

Causes the modem to report ringing, to detect busy but dial tone is 

ignored.

X6 

 Causes the modem to perform adaptive dialing (automatically determine 

if dialing can be performed using DTMF signaling), to report ringing, to 

detect busy and dial tones.

The user configuration stored in non-volatile memory is recalled to become the 

active configuration.

Z0

Resets modem and recalls user profile 0.

Z1 

Resets modem and recalls user profile 1. 

Z2 

Resets modem and recalls user profile 2. 

Z3 

Resets modem and recalls user profile 3. 

Note: The actual amount of profiles depends on the size of the non-volatile 

memory that a platform contains.