3Com SuperStack II Switch 1100 ATM Quick Installation Manual - page 4
4
C
HAPTER
: Q
UICK
I
NSTALLATION
G
UIDE
FOR
THE
S
UPER
S
TACK
II S
WITCH
1100/3300 ATM E
XPANSION
M
ODULE
IP Configuration
IP configuration is performed during installation and
does not need to be repeated thereafter.
1
Log into the web interface of the Switch.
2
Click on the ATM MODULE button of the web mimic
(see Figure 5).
Figure 5 Web Mimic Incorporating ATM Expansion Module
3
Fill in the fields of the IP address setup screen (see
Figure 6) generated as a result of step 1 and click
Apply.
Figure 6 IP Address Setup Form
4
Make sure the values used in step 3 are correct.
Incorrect value(s) generate IP address error message(s)
(see Figure 7). Fill in the correct value(s) and click
Apply. The web mimic will reappear.
Figure 7 IP Address Setup Error Message
5
To change any of the parameters, repeat steps 3 and
4. (After the first log-in, you don’t need the web
mimic, even though it reappears following step 4.)
Logging On
1
To begin a TELNET session, open it to the ATM
Module IP address. The following prompt is displayed:
SuperStack II 3300/1100 ATM Expansion Module
Software Version 1.0
Access Level: (read, write, admin)