3D Systems Cube 2nd Generation User Manual - page 35
42
WARNING –
PRINTJET NOZZLE TIP BECOMES EXTREMELY HOT DURING SET-UP AND OPERA-
TION. DO NOT TOUCH NOZZLE.
Do not change color of material or cartridge during printing; doing so may damage the
Cube.
NOTE: Your Cube will have printed test creations before leaving the factory. These test creations
may have been printed in a different material color than you are using. Therefore, a small amount
of material may be remaining in the print jet. The start of your first creation may have some of this
material color until it transitions over to your material color.
PRINTING YOUR FIRST CREATION
22
Togetstartedprintingyourfirstcreation;thecreationfilesthatweredownloadedwhenyouactivatedyouraccountora
.STLfilewillneedtobeconvertedtoa.Cubefile.ThisisthemachinecodefilethattheCubeprinterwillreadtobuildyour
creation.
WI-FI Connection: if you wished to connect to WI-FI via Ad hoc or WPS connection, please refer to Section 12, WI-FI
Set-Up and follow the step by step instructions. Then resume these instructions and follow the steps below to connect to
your Cube. These steps apply to both Ad Hoc and WPS connections.
1. OpenCubifySoftwareandclickon“Configure.”ClickonyourCubemodelinthedialogboxandclickon
“Connected. Your computer is now connected to your Cube.
Clickherefirst
Click here
second
Click here
third