3D Systems CubePro Original Instructions Manual - page 13

12

3D Systems, Inc

.

16.  Insert both (2) 2.5 mm hex head screws through the cartridge sensor 

and cartridge sensor shim. Secure the screws through the inner floor, 

to the cartridge bay.

CAUTION: Do not over-tighten the screws. Over-tightening 

the screws could damage the cartridge sensor and void the 

manufacturer’s warranty.

NOTE: Proceed to step 21 if no other parts are being 

replaced.

17.  To replace cartridge bay 2 PCB, loosen and remove both 2.5 mm hex 

head screws securing the cartridge bay sensor assembly to cartridge 

bay 2.

NOTE: To install cartridge bay 2 PCB, proceed to step 20.

18.  To replace cartridge bay 2, loosen and remove the four (4) 2.5 mm hex 

head cap screws (A) and 7 mm nuts (B) securing the lower hinge of 

cartridge 2 to the inner floor.

Bottom of Inner Floor

A

B