3D Systems ProX 950 Facility Requirements Manual - page 19

16

3D Systems, Inc.

APPENDIX B: PRE-INSTALLATION PREPARATION CHECKLIST

The following list helps you to prepare for your ProX 950. Prior to scheduling the installation appointment with a 3D Systems 

representative, complete the checklist and fax it to your 3D Systems Customer Support Engineer.

Is there an adequately rated forklift available 

during installation to move the equipment to its 

destination?

Have you coordinated the move with your shipping 

department?

Is there adequate doorway and hallway clearance 

to move system components using available mov-

ing equipment?

Is adequate space available for the equipment and 

supplies? (See “

Site Selection

” starting on Page 3)

Is the site prepared properly (according to the 

“

S

ite Selection

” on Page 3 of this guide)?

Are the following electrical power outlets in place?

For the ProX 950 : Do the electrical power 

requirements meet the specifications in “

Site 

Selection

” on Page 6 of this guide?

For service and other uses: Are there two ad-

ditional outlets, 110/220 V?

In the room where the ProX 950  will be installed  

does the air conditioning meet the following 

requirements?

Is there a minimum cooling capacity of 3.6 kW 

in the room?

Is the temperature change less than 1°C 

(1.8°F) per hour?

Is humidity maintained at an appropriate non- 

condensing level for the resin (20-50%)?

Does the air change two to five times per 

hour?

Is 10/100/1000BASE-T Ethernet network cabling 

installed and in working order?

Is a cabinet available to store resin containers?

Does the room have a door that can be closed and 

locked during installation?

Is there a network connection? (Optional)

Is there a telephone line? (Optional)

MOVING EQUIPMENT AND SITE ACCESSIBILITY

Is adequate space available for the equipment and 

supplies? (See 

Space Requirements

section on Page 

9)

Is all construction to floors, ceilings, and walls 

complete and does it meet local building code 

specifications? Are floors clean and free of debris? 

Are floors easily cleanable with solvents?

Have you decided what other equipment, acces-

sories, and supplies that you want to have with 

the ProX 950 ? Have you decided on a location for 

these items? (Refer to 

Figure 6

 on Page 3)

Has a compressed air connection with a pres-

sure controller and fast closing connection been 

installed? (Optional for parts finishing)

Is a workbench available that has negative pres-

sure and electricity for power hand tools?

Are electrical outlets and power available?

Is there a 110/220V outlet available for the Pro-

Cure UV Curing chamber?

Are there enough 110/220V outlets available in the 

room for equipment and tools?

Have you installed the duct (if required) for ventila-

tion of the ProCure UV Chamber?

Is all the recommended safety equipment avail-

able, including nitrile gloves and wipes?

WASTE DISPOSAL AND SAFETY

Has a local waste disposal company been arranged 

for periodic pickup of waste materials?

JOB SUBMISSION

(Workstations and Network Access)

Has 3D Systems software been loaded on at least 

one workstation so that we can submit a build job 

to the SLA system?

Is the software loaded?

Is the computer on the network?

FAX this completed page to (803) 324-4311

Completed by:

Customer Representative

Date

Assigned 3D Systems Customer Support

Engineer Forwarded Date

9 

PART FINISHING AREA

SLA SYSTEM AREA