3DHS Extra 330-E Assembly Manual - page 4
4
Items needed for completion:
✓ Masking tape
✓ Hobby knife with #11 blades
✓ Thin and medium CA. We highly recommend Mercury M5T thin and M100XF
medium formulas as well as the Mercury glue tips
✓ 30 minute epoxy. Pacer Z-Poxy is a long time favorite
✓ Goop Silicon glue
✓ Blue and Red Loctite
✓ Electric drill with an assortment of small drill bits
✓ Small flat head and Phillips head screw drivers
✓ Standard and needle nose pliers
✓ Side cutters
✓ Metric ball driver or allen key set
✓ Sanding block and sandpaper
✓ 5 x MKS HV-777A, HBL-380 X8 or comparable servos
✓ Extreme Flight Socket Head Servo Screws
✓ 2 x 1.5” Extreme Flight aluminum servo arms for the ailerons
✓ 2 x 2” Extreme Flight aluminum arms for the elevators
✓ 1 x 4” Extreme Flight double aluminum arm for pull-pull rudder.
✓ 1 1.5" Extreme Flight aluminum servo arm if using push-pull rudder
✓ 2 x Extreme Flight 6” 20 awg Servo Extensions.
✓ 2 x Extreme Flight 12” 20 awg Servo Extensions.
✓ 1 24" Extreme Flight 20 awg Servo Extension.
✓ 2 x 36” Extreme Flight 20awg Servo Extensions. If you need to remove the stabs for
transport use 48" extensions.
✓ 1 36" Extreme Flight 20 awg servo extensions if using rear mounted rudder servo
and push-pull assembly
✓ Extreme Flight Servo Safety Clips
✓ 4.5” Spinner
✓ Xpwr 60 Brushless Outrunner
✓ Castle Creations EDGE 160HV ESC running Firmware v4.22
✓ Series wiring harness to hook up 2 batteries in series with your choice of connectors
✓ Blazing Star XXL Standoff Set
✓ Xoar 24X10 or 24X12 PJN Electric Prop
✓ High quality High C rating 12S Lipo battereis 5000-8000 mah capacity
✓ Heavy duty Velcro and Velcro straps to secure batteries.
✓ Optional-Extreme Flight Anodized Washer sets to add some bling!