3Jtech netFox Wifi/GPS Camera Quick Installation Manual
Ver 1.0.0.1
Since 1988
1
Quick Installation Guide for netFox Wifi/GPS Camera
1. netFox Packing List :
Before you start installing netFox, please verify that the package contains the following items:
1x netFox
1x External GPS Antenna (Optional)
1x 12V/1A Adapter with Micro USB Connector
1x Mini USB Interface AV Cable with the Headset and Camera
1x 2G SD Card
1x CD with Demo Application Program and netFox User’s Guide
This Quick Installation Guide
NOTE: Please notify your sales representative immediately if any items listed above is missing or damaged.
2. Hardware Connection Settings for netFox
1) Use an AV cable to connect to the mini USB connector of netFox.
2) Make sure the SD card has inserted to the SD card slot of netFox (For its correct position,
please refer to the figure 2), and your wifi-router is ready as well.
3) Connect the power cable to the micro USB power connector of your netFox.
4) Press the “Push to Link” button (see the red arrow of the figure 2) to power on your netFox.
5) Insert CD to your PC to install the netFox AP. (Refer to Section 4.)
NOTE 1 : The procedures of powering on netFox will take 1 minute around. And also make sure that netFox
has been charged for 4 hrs in your first use.
NOTE 2 : netFox will allow the image and voice on the spot to be remotely transmitted to PC/server running
netFox AP by pressing the “Push to Link”
button while netFox is powering on. And keep pressing
the “Push to Link”
button over 3 seconds, netFox will be powered off.