Operator’s manual 701 test kit for static control surfaces (megohmmeter).
Intended use the 3m model 701 megohmmeter is designed to measure the resistance of static control work surfaces and flooring. This is to be done in a manner as described in this operator's manual. Measurements described in this manual refer to the esd association standards s4.1 (worksurfaces-resisti...
7. Mechanical zero adjust: this control is used to zero the pointer. Operating instructions • turn off the instrument before connecting or disconnecting test leads, or before moving test weights. • do not use this instrument with any accessories not specifically designed to be used with this product...
Off 10v 100v battery test continuity test test read manual before use ohms surface test taut band suspension 10 9 1g 10g fail pass 10 10 10 11 100g 10 8 10 7 10 6 10 5 0 1m 100k 0 10m 100m continuity battery 100v 0 10k 100k 1m 10m 100m figure 5-1: periodic performance tests of installed surfaces off...
D. Surface-to-groundable point test: test samples per figure 5-4, using both the 100 volts and 10 volts surface test ranges at 50% rh and record the values as (r ts-gp ). Procedure: place the instrument on a table top or other stable surface. Connect the test leads to the instrument by means of the ...
B. Before testing new floor mats or newly installed floors, clean mats/floors per manufacturer's recommendations. For testing of floor finishes or monitoring of existing floor materials, test in an as-is condition. C. Perform tests at ambient humidity. D. Place the instrument and test weight at the ...
Replacement parts the following parts are user-replaceable parts: description part number model 701 megohmmeter 3m 701-m, 98-0798-2290-8 test weight (each) 3m 701-w, 98-0798-2291-6 test leads (pair) 3m 701-l, 98-0798-2292-4 carrying case 3m 701-c, 98-0798-2293-2 insulated “bulldog” clip 3m 3037, 98-...
Electronic and interconnect solutions division 6801 river place blvd. Austin, tx 78726-9000 © 3m 2003 78-8132-1177-4 important notice before using this product, you must evaluate it and determine if it is suitable for your intended application. You assume all risks and liability associated with such...
