1. DL manuals
  2. 3M
  3. Projector
  4. 9000PD
  5. Operator's Manual

3M 9000PD Operator's Manual

Manual is about: 3M Digital Wall Display Operator's Guide

Summary of 9000PD

  • Page 1

    February 2005 78-6970-9380-1 rev. B copyright © 2004, 3m. All rights reserved. …for projection 9000pd operator’s guide.

  • Page 2

    (this page intentionally left blank for printed version).

  • Page 3: Contents

    3 3m™ digital walldisplay © 3m 2005. All rights reserved. Contents contents introduction thank you for choosing 3m .........................................................................................................................5 safety information ..............................................

  • Page 4

    4 3m™ digital walldisplay © 3m 2005. All rights reserved. Contents contents menu system menu navigation .........................................................................................................................................26 colorful—bright slider ....................................

  • Page 5: Introduction

    5 introduction 3m™ digital walldisplay © 3m 2005. All rights reserved. Introduction thank you for choosing 3m thank you for choosing 3m equipment. This product has been produced in accordance with 3m’s highest quality and safety standards to ensure smooth and troublefree use in the years to come. Fo...

  • Page 6

    6 introduction 3m™ digital walldisplay © 3m 2005. All rights reserved. Warning to reduce the risk associated with hazardous voltage: • do not attempt to service the wall display other than performing routine lamp replacement. Service should only be performed by a 3m authorized service provider. Asid...

  • Page 7

    7 introduction 3m™ digital walldisplay © 3m 2005. All rights reserved. Warning to reduce the risk of environmental contamination due to lead based solder: • don’t throw circuit boards in the trash. Dispose of circuit boards in accordance with your respective governmental agencies for hazardous waste...

  • Page 8

    8 introduction 3m™ digital walldisplay © 3m 2005. All rights reserved. Important notes • in some countries, the voltage is not stable. This appliance is designed to operate within a range of 100~240 vac. In these countries, it is recommended to install a power stabilizer unit. • do not manually open...

  • Page 9

    9 introduction 3m™ digital walldisplay © 3m 2005. All rights reserved. Product safety label the following safety label is used on or within the 3m digital walldisplay to alert you to this area requiring your attention. Wall display fro m 3 m save these instructions the information contained in this ...

  • Page 10

    10 introduction 3m™ digital walldisplay © 3m 2005. All rights reserved. Netscape and the netscape n and ship’s wheel logos are registered trademarks of netscape communications corporation in the u.S. And other countries. Navigator and communicator are also trademarks of netscape communications corpo...

  • Page 11

    11 introduction 3m™ digital walldisplay © 3m 2005. All rights reserved. Model identification and differences identify model the nameplate, located behind the storage door, identifies the 3m digital walldisplay (dwd). Push the storage door to open it. The figure below shows the nameplate, and the tab...

  • Page 12

    12 introduction 3m™ digital walldisplay © 3m 2005. All rights reserved. Contents the 3m digital walldisplay is shipped with the necessary cables required for standard vcr, pc, macintosh or laptop computer connections. Carefully unpack and verify that you have all of the items shown below. If any are...

  • Page 13

    13 introduction 3m™ digital walldisplay © 3m 2005. All rights reserved. Pc audio usb mouse serial mouse rs-232 audio video computer row 1 2 (this row for digital whiteboard option only) printer computer s-video rca vga dvi-d out in menu keypad 1 2 3 4 wall display fro m 3 m part identification 1 3 5...

  • Page 14

    14 introduction 3m™ digital walldisplay © 3m 2005. All rights reserved. 3m digital walldisplay features the 3m digital walldisplay combines the following features into one sleek, sophisticated package. • full connectivity for computer or video presentations • large 60˝ diagonal screen • 4:3 screen a...

  • Page 15

    15 3m™ digital walldisplay © 3m 2005. All rights reserved. Installation and system setup installation and system setup recommendation and things to consider before installing location of unit • place near ac outlet. The ac power connection is located on the lower-left corner of the 3m digital walldi...

  • Page 16

    16 3m™ digital walldisplay © 3m 2005. All rights reserved. Installation and system setup installing the wall bracket unpacking wall bracket and hardware 1. Place the shipping container face up on the floor. 2. Open the end of the shipping container. 3. Slide the shipping tray partially out the conta...

  • Page 17

    17 3m™ digital walldisplay © 3m 2005. All rights reserved. Installation and system setup hanging the 3m digital walldisplay unpacking the 3m digital walldisplay 1. Place the shipping container face up on the floor and open the end previous opened. 2. Slide the shipping tray out of the shipping conta...

  • Page 18

    18 3m™ digital walldisplay © 3m 2005. All rights reserved. Installation and system setup hanging on the wall 1. If possible, position the 3m digital walldisplay and shipping tray in front of the wall where the bracket is located. Position the unit so that the projection arm is closest to the wall. 2...

  • Page 19

    19 3m™ digital walldisplay © 3m 2005. All rights reserved. Installation and system setup system setup it only takes a few minutes to connect the 3m digital walldisplay to your computer, vcr, dvd player, video conference unit, or other devices. The connection panel is located underneath the bottom ri...

  • Page 20: Operation

    20 3m™ digital walldisplay © 3m 2005. All rights reserved. Operation operation startup 1. Plug power cord into wall socket. 2. Flip on the master power switch beneath the lower left corner of the 3m digital walldisplay, near the 3m label. This should stay on at all times. Now the 3m digital walldisp...

  • Page 21

    21 3m™ digital walldisplay © 3m 2005. All rights reserved. Operation shutdown 1. Press the on/off button on the bottom center panel of the 3m digital walldisplay unit. 2. The lamp will turn off and the projector arm will return to its housing. The on/off button will flash red as the arm closes. Note...

  • Page 22: Remote Control Unit

    22 3m™ digital walldisplay © 3m 2005. All rights reserved. Remote control unit remote control unit features the remote control sensor is on the front lower panel of the 3m digital walldisplay unit. The distance between the sensor and remote control must be shorter than 4 meters (13 feet). The remote...

  • Page 23

    23 3m™ digital walldisplay © 3m 2005. All rights reserved. Remote control unit forward keypad power press to turn the 3m digital walldisplay on/off. When power is turned on, the 3m digital walldisplay will automatically extend the projection arm and ignite the lamp. Mute press to temporarily turn of...

  • Page 24

    24 3m™ digital walldisplay © 3m 2005. All rights reserved. Remote control unit rear keypad pointer press to turn the pointing function on/off. A green dot will appear on the screen. The dot can be controlled by pressing the arrows on the disk pad . Volume press the + button to increase or the - butt...

  • Page 25

    25 3m™ digital walldisplay © 3m 2005. All rights reserved. Remote control unit installing or replacing batteries 1. Push and slide the battery compartment tab in the direction shown, then lift it off. 2. Install two aaa batteries as indicated by the diagram inside the compartment. 3. Snap the batter...

  • Page 26: Menu System

    26 3m™ digital walldisplay © 3m 2005. All rights reserved. Menu system menu system menu navigation most adjustments and settings are available in the main menu and sub-menus. To navigate and make adjustments, use the 3m digital walldisplay’s menu keypad button or the remote control’s menu and disk p...

  • Page 27

    27 3m™ digital walldisplay © 3m 2005. All rights reserved. Menu system warm—cool slider the warm—cool slider adjusts the color temperature. Move the slider toward warm to achieve warmer, more reddish images. Move the slider toward cool to achieve cooler, more bluish images. To adjust the warm—cool s...

  • Page 28

    28 3m™ digital walldisplay © 3m 2005. All rights reserved. Menu system mute menu function the mute menu function turns the sound on and off. To turn the mute menu function on: 1. Open the menu system by pressing the remote control menu button or any arrow on the menu keypad . 2. Select the mute menu...

  • Page 29

    29 3m™ digital walldisplay © 3m 2005. All rights reserved. Menu system input select menu the input select menu defines the displayed video source. When input select menu is selected, the current video source is shown. The input options are: computer (vga input), dvi-d, s-video, comp. Video (rca vide...

  • Page 30

    30 3m™ digital walldisplay © 3m 2005. All rights reserved. Menu system image adj sub-menu the image adjustment sub-menu adjusts the projected image settings for the vga and dvi-d inputs. Use the vertical position and horizontal position sliders to reposition an image if portions are not visible. Use...

  • Page 31

    31 3m™ digital walldisplay © 3m 2005. All rights reserved. Menu system tools sub-menu the tools sub-menu provides access to the following settings and tools: onscreen timer allows you to set a timer and display it onscreen. Language selects which language to use for onscreen commands. (default langu...

  • Page 32: Maintenance

    32 3m™ digital walldisplay © 3m 2005. All rights reserved. Maintenance maintenance general maintenance for general cleaning of the screen and exterior of the 3m digital walldisplay, use a damp cloth or dry cleaning cloth such as the 3m high performance cleaning cloth. Standard dry-erase cleaners may...

  • Page 33

    33 3m™ digital walldisplay © 3m 2005. All rights reserved. Maintenance lamp replacement 1. Turn the power off and disconnect the power cord from the outlet. 2. Allow approximately 45 minutes for the lamp to cool, if necessary. 3. There are two indentations behind the top of the facade, near each end...

  • Page 34

    34 3m™ digital walldisplay © 3m 2005. All rights reserved. Maintenance 5a. Hold down this receptacle with your left thumb and (5b) pull connectors out of the receptacle with other hand. 5b 5a 6. Open the latch by moving the metal lever to the left. Lever 7. While holding the latch open, grasp the la...

  • Page 35

    35 3m™ digital walldisplay © 3m 2005. All rights reserved. Maintenance 11. Align the slots and tabs of the right side of the facade and projection arm as shown, then snap firmly into place. 12. Align the slots and tabs of the left side of the facade and projection head as shown, then snap firmly int...

  • Page 36

    36 3m™ digital walldisplay © 3m 2005. All rights reserved. Maintenance resetting lamp hours please do the following within 10 minutes of turning power on after you replace the lamp. 1. Press the menu keypad or the menu button on the remote control and use the disk pad to scroll down to the tools men...

  • Page 37

    37 3m™ digital walldisplay © 3m 2005. All rights reserved. Maintenance replacing projectionscreen replacing the 3m digital walldisplay screen is very simple. 1. Turn off the 3m digital walldisplay and disconnect the power cord from the wall outlet. 2. Remove the right and left side bezels. There are...

  • Page 38

    38 3m™ digital walldisplay © 3m 2005. All rights reserved. Maintenance optical engine adjustment the optical engine needs to be aligned when the vertical or horizontal images do not cover the screen or are tilted. Note: before continuing with this adjustment, move the arm assembly up and down to rel...

  • Page 39

    39 3m™ digital walldisplay © 3m 2005. All rights reserved. Maintenance 4. Loosen locking screw. Then use blade screwdriver on adjustment screw to move screen image from side to side if required. Tighten locking screw. 5. Locate adjustment screw for right side screen adjustment. Locate locking screw ...

  • Page 40

    40 3m™ digital walldisplay © 3m 2005. All rights reserved. Maintenance 7. Locate adjustment screw for left side screen adjustment. Locate locking screw for left side adjustment. 8. Loosen locking screw. Then use blade screwdriver on adjustment ...

  • Page 41: Troubleshooting

    41 3m™ digital walldisplay © 3m 2005. All rights reserved. Troubleshooting troubleshooting common problems and solutions symptom cause solution power cannot be turned on. The power cord is disconnected. Insert the power cord into an ac socket. The master power switch is not turned on. Turn on the ma...

  • Page 42

    42 3m™ digital walldisplay © 3m 2005. All rights reserved. Troubleshooting common problems and solutions symptom cause solution desired input source cannot be detected. The input source is not active. A signal must be present for the input to be selected. Connect an active input source to unit. The ...

  • Page 43: Service Information

    43 3m™ digital walldisplay © 3m 2005. All rights reserved. Service information service information replacement parts description part number power cord (eu) 78-8131-0004-3 power cord (us) 78-8131-0005-0 power cord (uk) 78-8131-0003-5 serial mouse cable 26-1015-0423-6 usb cable 26-1015-0424-4 vga cab...

  • Page 44: Appendix

    44 3m™ digital walldisplay © 3m 2005. All rights reserved. Appendix appendix 3m™ digital walldisplay specifications display size 60" diagonal viewing area display aspect ratio 4:3 display system single chip, dlp™ texas instruments technology dlp chip chip diagonal size 0.7 inch number of pixels 1024...

  • Page 45

    45 3m™ digital walldisplay © 3m 2005. All rights reserved. Appendix input/output signal specifications computer video signal analog 0.7vp-p, 75 ohms termination (positive polarity) horizontal sync signal ttl level (positive/negative polarity) vertical sync signal ttl level (positive/negative polarit...

  • Page 46

    3m austin center building a145-5n-01 6801 river place blvd. Austin, tx 78726-9000 3m canada p.O. Box 5757 london, ontario n6a 4t1 3m mexico, s.A. De c.V. Apartado postal 14-139 mexico, d.F. 07000 mexico 3m europe boulevard de l’oise 95006 cerge pontoise cedex france litho in usa copyright © 2002 3m ...