3M DF1XX Instruction Manual - page 4
Product Dimensions
Step 2
Step 3
Step 4
Step 1
This product is outfitted with inlet/outlet fittings. The fittings can be attached or removed from the system
without tools. Retention clips are semi-circular in shape with three internal tabs, bottom, center and top. Tab interlaces
with windows in the manifold head near each connection port. Clip is flexible and easily assembled following these
instruction and illustrations.
1. Insert fitting into manifold.
2. With fitting inserted into manifold port, snap clip into place beginning at the bottom window
3. Push center tab into center window.
4. Finally push top tab into top window.
How to Use the Inlet/Outlet Fitting Retention Clips
This product is outfitted with a user friendly ‘Push In’ connector at the vent valve. Proper use of the connectors is
shown in the figure below. It is most important that the tubing selected for use with these connectors be of high
quality, exact size and roundness, and with no surface nicks or scratches. If it is necessary to cut the tubing, use
a plastic tubing cutter or sharp razor knife. Make a clean square cut. Should a leak occur at a "Push-In" con-
nector, the cause is usually defective tubing.
To Fix:
1. Relieve pressure
2. Release tubing
3. Cut off at least 1/4” from end
4. Reattach tubing
5. Confirm connection is leak free
How to Use “Push-in” Connectors
4
5 3/8"
(13.7 cm)
24 1/16"
(61.1 cm)
22 7/8"
(58.10 cm)
Minimum of 3" (7.6 cm)
For Cartridge Change
16 7/8"
(42.9 cm)
5 1/8"
(13.0 cm)
24 1/16"
(61.1 cm)
Minimum of 3" (7.6 cm)
For Cartridge Change
DF1
DF2
1
1
2
2
To Release Tubing
To Attach Tubing
Push tubing straight in as far
as it will go.
Tubing is secured in.
Push in collt to release tubing.
Pull tubing straight out.