3M Digital Projector WX66 Product Safety Manual - Installing The Batteries

3M™ Digital Projector WX66 Product Safety Guide

13

ENGLISH

© 3M 2008. All rights reserved.

Installing the batteries

Please load the batteries before using the remote control. If the remote control starts to malfunction, replace 

the batteries. If you will not use the remote control for an extended period, remove the batteries from the 

remote control and store them in a safe place.

1.    Slide back and remove the battery cover in the 

direction of the arrow.

2.    Align and insert the two AA batteries (HITACHI 

MAXELL Part No.LR6 or R6P) according to 

their plus and minus terminals as indicated in the 

remote control.

3.    Replace the battery cover in the direction of the 

arrow and snap it back into place.

Remote control

WARNING

CAUTION

•  To reduce the risk associated with choking:

  -  Keep the battery away from children and pets.

•  To reduce the risk associated with environmental contamination:

-   Dispose of exhausted batteries in accordance with applicable federal, state, and 

local regulations.

•   To reduce the risk associated with explosion, and/or chemicals from a leaking 

batteries:

-   Use only with battery type AA (HITACHI MAXELL Part No.LR6 or R6P).

-   Orient the battery's plus (+) and minus (-) terminals of the batteries according to 

the markings found on the remote control or internal clock battery case.

-  Do not leave the battery in the remote for an extended period of time.

-  Do not heat, disassemble, short, recharge, or expose to fire or high temperature.

-  Do not carry batteries loose in your pocket or purse.

-  Avoid eye and skin contact in the event that battery would leak.

-  Do not mix used and new batteries.

-  Obey the local laws on disposing the battery.