3M Dynapro 350 Monitor, ET 3170 Terminal and ET 3200 Series Computers Installation Manual
Installing the Rack Mount
ET 350 Monitor, ET 3170 Terminal, and ET 3200 Series Computers
Equipment
Materials supplied
The Rack Mount Kit comes with the following items:
!
1 rack adapter (the example illustrated below is
the adapter for the ET 3170 Terminal or ET 3210
Computer)
!
8 clip nuts
!
12 Phillips #10-32 x ½ inch panhead machine
screws
!
12 flat washers
!
12 lock washers
!
8 slotted #10-32 x 5/8 inch countersunk machine
screws
!
8 cup washers
Tools Required
!
No. 2 Phillips screwdriver
!
Large flat-blade screwdriver
Intended Use
When properly installed using the materials provided,
and according to these instructions, the rack mount is
intended to mount the ET 350 Monitor, the ET 3170
Terminal, and ET 3200 Series Computers for use in a
standard 19-inch EIA rack.
Warning
Read and understand all safety information
before installing and using this product.
To reduce the risk of fire or electric shock
which could result in serious personal injury or
death:
!
Follow all product and accessory installation
instructions.
!
Consideration should be given to the connection of
the equipment to the supply circuit and the effect that
overloading of the circuits might have on overcurrent
protection and supply wiring. Appropriate
consideration of equipment nameplate ratings should
be used when addressing this concern.
!
Reliable earthing of rack-mounted equipment should
be maintained. Particular attention should be given to
supply connections other than direct connections to
the branch circuit (e.g., use of power strips).
Caution
To reduce the risk of fire which may result in
minor or moderate injury or cause property
damage:
!
Use the materials provided so that installation of the
ET unit will not result in a hazardous condition due to
uneven mechanical loading.
!
Installation of the equipment in a rack should be such
that the amount of air flow required for safe operation
of the equipment is not compromised.
73145_a