1. DL manuals
  2. 3M
  3. Carbon Monoxide Alarm
  4. Macurco CM-16A
  5. User Instructions

3M Macurco CM-16A User Instructions

Summary of Macurco CM-16A

  • Page 1

    3 macurco ™ carbon monoxide detector cm-16a user instructions for 3m™ macurco™ carbon monoxide detector (co) cm-16a important: these user instructions are to be provided to the homeowner/end user upon product installation. Each person installing or using this equipment must read and understand the i...

  • Page 2

    1 general safety information .......................................................2 intended use ..................................................................................2 list of warnings and cautions ........................................................2 use instructions and limitati...

  • Page 3

    2 3 general safety information intended use the cm-16a is a low voltage (12-24v ac or dc) detector of carbon monoxide (co). The cm-16a is designed for connection to fire alarm/burglary control panels or as a stand alone unit. This carbon monoxide detector is designed to detect co gas from any source...

  • Page 4

    4 5 installation and operation instructions the following instructions are intended to serve as a guideline for the use of the 3m™ macurco™ carbon monoxide detector cm-16a. It is not to be considered all-inclusive, nor is it intended to replace the policy and procedures for each facility. This detec...

  • Page 5

    6 7 this product is intended for use in ordinary indoor locations of family living units and office workspaces. The cm-16a is not designed to measure compliance with occupational safety and health administration (osha) commercial or industrial standards. Do not mount the unit in the garage. Do not m...

  • Page 6

    8 9 power up when the unit is turned on it performs a self-test, which activates the visual alarm. If the self-test fails, or the alarm does not activate, do not use. Failure to do so may adversely affect product performance and result in sickness or death. When the detector is first powered, the st...

  • Page 7

    10 11 do not cover or obstruct visual alarm led. Doing so may adversely affect product performance and result in sickness or death. Trouble indicator internal failure of the cm-16a will cause an open circuit in the normally closed (nc) trouble relay to provide for actuation of the control panel circ...