3m occupational health and environmental safety division 3m ™ noisepro ™ personal noise dosim eter noisepro series quick start guide.
Turn on 1. Turn on the noisepro by pressing and releasing key. The display will initialize and sequence to the “start” screen. 2. If “lobat” is in display, put new batteries in the noisepro. 3. Press and hold reset softkey. The display counts down from 5 then shows “sessions deleted” for noisepro dl...
Begin study 8. Clip the microphone, with windscreen attached to one’s shoulder and secure the noisepro to the person’s waist. 9. Press key to begin data collection. The run icon will appear in the lower right corner of the display. End study 10. Press key to stop study. The pause icon “ ii ” will ap...
Noisepro overview softkey menus softkeys (used for additional menu options) up/down arrow keys left/right arrow keys escape on/off enter key start/stop studies.
Common noise dosimeter terms criterion level (cl) - expressed in decibels (db), it is the maximum allowable accumulated noise level that results in 100% dose. Regional noise standards specify criterion level. Dose - expressed in percent, it is the percent of the maximum exposure that has accumulated...
Pre-defined setups six of the nine dosimeter setups are factory-defined and conform to standards established for noise dosimetry in the united states and the european union. It is recommended to check your regulations prior to data collection. Osha hc (hearing conservation) • “a” weighting • slow re...
Occupational health & environmental safety division quest technologies, a 3m company iso 9001 registered company iso 17025 accredited calibration lab 1060 corporate center drive oconomowoc, wi 53066 customer service: 262-567-9157 toll free: 800-245-0779 www.3m.Com/detection www.Questtechnologies.Com...
