3M QUESTemp 32 Quick Start Manual - Questempo 32 Components
QUESTempo 32 components
Two line Display
Sensor Bar 2&3
Dry bulb thermometer
Up and Running
1.
Make sure the wet bulb wick is clean. Fill reservoir with distilled water. See
“Filling wet bulb reservoir” below.
2.
Place the instrument in the work area approximate 3.5 feet off the ground.
3. Power on the instrument by pressing I/O Enter key and check the battery. (If
the battery is less than or equal to 6.4 volts, replace or recharge the battery.)
4. Allow 10 minutes for sensors to stabilize.
5. The measurements will be displayed. Press I/O Enter key to page through the
screens.
•
Screens include: Wet Bulb and Dry Bulb screen, Globe screen, WBGTi
and WBGTo screen, RH and H.I. screen, and BAT (Battery voltage)
Filling wet bulb reservoir:
Remove the reservoir cover & fill with distilled or
de-ionized water. Replace cover.
Removable sensor bar
Globe Thermometer
Natural wet bulb thermometer
Up/down arrow keys
I/O Enter key
Setup key
Wick
Reservoir cover
Reservoir