3M SGLP-RO Quick Installation Manual

Summary of SGLP-RO

  • Page 1

    Model sglp-ro reverse osmosis system- quick installation guide note: installer - please leave with owner/operator. 3m™ water filtration products.

  • Page 2

    Notice: to reduce the risk associated with property damage due to water leakage or flooding: • read and follow use instructions before installation and use of this system. • change the disposable prefilter and ro membrane at the recommended interval; the disposable pre- filter and ro membrane must b...

  • Page 3

    Step 1: unpack the sglp-ro system check that all of the parts listed below are included in the packaging. Should any parts be missing, please contact 3m at (866) 990-9785. Item description 1 tank and bracket assembly (incl. Permeate pump) 2 scalegard™ prefilter (part # 5570613) 3 scalegard™ ro membr...

  • Page 4

    Step 2: mount the sglp-ro system 7.000 .450 .750 1) select the location to mount the sglp-ro unit. (sglp-ro overall dimensions: 12-1/4” w x 17-3/4” h x 9-5/16” d). 2) allow clearance on each side of the system for inlet and outlet tubing connections. 3) allow 3” clearance below the system for cartri...

  • Page 5

    Step 3: connect water supply to the sglp-ro system step 4: remove sw-ix-60 cartridge and install filter plug included with the ro system (for sw4-plus only) note: if possible, the water supply should be tee’d off of the existing filter system. Refer to installation diagrams below. For sw3-plus and s...

  • Page 6

    Step 5: complete plumbing connections on sglp-ro system note: refer to installation diagram above. 1) install installation parts onto the sglp-ro unit and close the inlet and sample water valves. 2) connect inlet water supply to the sglp-ro system inlet using either the quick connect fitting or the ...

  • Page 7: Bulkhead Fitting

    Step 6: install ro prefilter cartridge and ro membrane prefilter: 1) remove red cap for ro prefilter and moisten o-ring with water. 2) insert new ro prefilter into the filter head. Be sure that the ears on the ro prefilter line up with the spaces in the head. 3) turn the ro prefilter ¼ turn to the r...

  • Page 8

    System tested and certified by nsf international against std 58 and csa b483.1 for the reduction of claims listed on the performance data sheet. 3m and scalegard are trademarks of 3m company. Nsf is a trademark of nsf international. All other trademarks are the property of their respective owners. P...