1. DL manuals
  2. 3M
  3. Water Filtration Systems
  4. SGLP100-CL
  5. Installation And Operating Instructions Manual

3M SGLP100-CL Installation And Operating Instructions Manual

Summary of SGLP100-CL

  • Page 1

    Installer: please leave this manual with owner/operator. Sglp100-cl sglp200-cl sglp200-cl-bp 3m tm water filtration products installation and operating instructions for sglp100-cl, sglp200-cl and sglp200-cl-bp reverse osmosis filtration systems.

  • Page 2

    1 intended use statement: sglp100-cl, sglp200-cl and sglp200-cl-bp are intended for use in filtering potable water and have not been evaluated for other uses. The products are installed at the point of use and must be installed as specified in the installation instruction by a qualified professional...

  • Page 3

    2 • where a booster pump is installed on a water system, you must maintain and inspect the attached pressure switch regularly in accordance with the booster pump manufacturer’s instructions. Contact a plumbing professional if you are uncertain how to maintain your booster pump system. • where a boos...

  • Page 4

    3 product specifications model number part number description capacity 2 sglp100-cl 5636201 reverse osmosis system 100 gpd (379 lpd) cfs m 5625004 ro membrane 100 gpd (379 lpd) hf65-cl 5628902 pre-filter 15,000 gallons (56,781 liters) at 1 gpm (3.81 lpm) sglp200-cl 5636202 reverse osmosis system 200...

  • Page 5

    4 plumbing connections note: the sglp100-cl, sglp200-cl and sglp200-cl-bp reverse osmosis water filtration system requires a minimum 60 psi inlet water pressure. If inlet water pressure is less than 60 psi, a water booster pump may be required depending on the minimum delivery pressure requirements ...

  • Page 6

    5 to drain outlet to equipment water inlet inlet optional service loop water valve (not included) water sample valve tank shut-off valve if installing cleaning bypass, please refer to page 13 water valve (not included) water valve (not included) sglp100-cl printed colors – front: requester: susan ba...

  • Page 7

    6 notice to reduce the risk associated with water leakage or flooding: • change the disposable pre-filter at the recommended interval; the disposable pre-filter must be replaced every 12 months or sooner. • change the disposable filter ro membrane at the recommended interval; the disposable ro membr...

  • Page 8

    7 membrane (replace every 24 months) 1. Close tank shut-off and inlet valves. 2. Turn used ro membrane cartridge 1/4 turn to the left. 3. Pull down on cartridge. 4. Remove the tubing from the fitting (refer to figure 4). 5. Discard used cartridge. 6. Remove red cap from new membrane and moisten the ...

  • Page 9

    8 check tank pressure when: yearly tools: piece of 3/8” tubing or bucket bicycle or tire pressure gauge bicycle tire pump 1. Drain water from the storage tank. A. Shut off the inlet water supply by removing the pre-filter or water booster system if applicable. B. Make sure the tank shut-off valve lo...

  • Page 10: Preliminary

    9 product dimensions (figure 4) part number description 5625004 ro membrane cartridge 5628902 hf65-cl pre-filter 89-1331202 permeate-pump 99-103301 flow control 96-410502 regulator, 80 psi 60-931401 automatic shut-off valve 56-12301 tank 60-235280 tank shut-off valve contact dealer for replacement p...

  • Page 11

    10 troubleshooting guide problem cause solution notes unit never produces ro water/only provides bypass water low feed water pressure repair existing booster pump contact dealer add water booster pump only if booster pump is not installed. Unit runs low or out of water low feed water pressure repair...

  • Page 12

    11 code indent. No.: do not scale hard copy drawings third angle projection mm inch x .X .Xx .Xxx dwg size checked title sheet document number rev drawn names unless otherwise specified dimensions are in inches. .X .Xx .Xxx .0005 .Xxxx .1 .01 .005 0.010 0.25 0.1 0.05 1 angles approver date standard ...

  • Page 13: Limited Warranty

    12 limited warranty product use: many factors beyond 3m’s control and uniquely within user’s knowledge and control can affect the use and performance of a 3m product in a particular application. Given the variety of factors that can affect the use and performance of a 3m product, user is solely resp...

  • Page 14

    13.

  • Page 15: Notes

    14 notes.

  • Page 16

    3m purification inc. 400 research parkway meriden, ct 06450 usa toll free: 866.990.9785 worldwide: 203.237.5541 fax: 203.238.8701 www.3mfoodservice.Com www.3mpurification.Com 3m is a trademark of 3m company. Schrader is a trademark of schrader international, inc. 34-8717-8351-9 © 2015 3m company. Al...