3onedata GW1101 series User Manual - page 2
1. RS-232 Serial
2. Ethernet port LED indicator
3. Power LED indicator
4. Serial receive data indicator
5. Serial transmit data indicator
6. Wall mounting installation
7. 10Base-T /100Base-TX Ethernet port
8. DIP switch
9. Power input 9~48VDC
GW1101-1D (RS-485)-P(9~48VDC)
1. RS-485/422 Serial
2.
Ethernet port LED indicator
3. Power LED indicator
4. Serial receive data indicator
5. Serial transmit data indicator
6. Wall mounting installation
7. 10Base-T /100Base-TX Ethernet port
8. DIP switch
9. Power input 9~48VDC
【
Appearance and dimension】
The shell size of the series is the same, but the type of the
interface is different. Unit (mm)
【
Power supply input】
GW1101 series provide DC power input, voltage input is the
two terminal form, plug type 2 core spacing of 5.08mm terminals,
wherein the power input range of 9 ~ 48VDC. (V+, V-)
【
DIP switch】
Top panel provide 4 bit DIP switch to set function(ON is
effective), 1, 3, 4 is hold, 2 is factory default, if you change the
DIP switch statue, please power off and power on.
【
Communication connector】
The series products support 1 Ethernet ports and 1 serial ports
(RJ45 or 5 bit terminal interface).
10/100BaseT(X) Ethernet port
The pinout of RJ45 port display as below, connect by UTP or
STP. The connect distance is no more than 100m. 100Mbps is
used 120Ω of UTP 5; 10Mbps is used 120Ω of UTP 3, 4, 5.
RJ 45 port support automatic MDI/MDI-X operation. Can
connect the PC, Server, Converter and HUB .Pin 1,2,3,6
Corresponding connections in MDI. 1→3, 2→6, 3→1, 6→2 are
used as cross wiring in the MDI-X port of Converter and HUB.
10Base-T/100Base-TX are used in MDI/MDI-X, the define of Pin
in the table as below.
NO.
MDI signal MDI-X signal
1
TX+
RX+
2
TX-
RX-
3
RX+
TX+
6
RX-
TX-
4, 5, 7, 8
—
—
Note:“TX±”Transmit Data±,“RX±”Receive Data±,“—”Not Use.
1
8