3xLogic VSX-PTZ-2MP-EXT Installation Manual - page 22
Installation Manual
| VISIX PTZ Network Camera
10225 Westmoor Drive, Suite 300, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
22
Figure 2-‐17 Remove the Protective Accessory
4) Drill a hole on the ceiling according to the drill template (supplied).
NOTE:
±
2mm of the diameter of the circle is tolerable.
Figure 2-‐18 Draw and Cut Hole on the Ceiling
5) Connect the cables.
The cables have been connected to the corresponding interfaces. Connect the power cable and the red LED indicator
turns on when the power is on.
NOTE:
Please turn the power off after checking the speed dome.
6) Install the speed dome.
Steps:
1)
Loosen the two lock screws on both sides of the back box and make the locks in internal position, as shown in
the following figure:
Lower Dome
Protective
Foam
Sticker
Back Box
Lens Cover