3xLogic VSX-PTZ-2MP-EXT User Manual - Ptz Configuration
User Manual
| VISIX 5 Inch Speed Dome Camera
5
PTZ Configuration
5.1
Configuring Initial Position
Purpose:
The initial position is the origin of PTZ coordinates. It can be the factory default initial position. You
can also customize the initial position according to your own demand.
!
Customize an Initial Position:
Steps:
1)
Enter the Initial Position Configuration interface:
Configuration
>
Advanced Configuration
>
PTZ
>
Initial Position
Figure 5-‐1
PTZ Configuration
2)
Click the PTZ control buttons to find a position as the initial position of the dome; you can
also call a defined preset and set it as the initial position of the dome.
3)
Click
Set
to save the position.
!
Call/Delete an Initial Position:
You can click
to call the initial position. You can click
to delete the
initial position and restore the factory default initial position.
5.2
Configuring Basic PTZ Parameters
Purpose:
You can configure the basic PTZ parameters, including proportional pan, preset freezing, preset speed,
etc.
1)
Enter the Basic PTZ Parameter Configuration interface:
Configuration
>
Advanced Configuration
>
PTZ
>
Basic