3xLogic VX-2M-D2-RIA User Manual - page 84
VISIX S-Series Network Camera |USER MANUAL v6.0
10385 Westmoor Drive, Suite 210, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
84
Figure 6-42
Time Settings
Configuring Time Synchronization by NTP Server
Steps:
(1) Toggle the radio button to enable the NTP function.
(2) Configure the following settings:
Server Address: IP address of NTP server.
NTP Port: Port of NTP server.
Interval: The time synchronization interval. It can be set from 1 to 10080 minutes.
Figure 6-43
Time Sync by NTP Server
Click
to make sure that the NTP server is connected.
NOTE
: If the camera is connected to a public network, you should use an NTP server that features
time synchronization capability, such as the server at the National Time Center (IP Address:
210.72.145.44). If the camera resides in a customized network, NTP software can be used to establish
a NTP server for time synchronization.
Configuring Time Synchronization Manually
Steps:
(1) Toggle the Manual Time Sync radio button.
(2) Click
to set the system time from the pop-up calendar.
(3) Click
to save the settings.
NOTE:
The user can also toggle the Sync with local time checkbox to synchronize the time of the
camera with the time of your computer.