4IPNET EAP110 Quick Installation Manual - System Overview
Quick Installation Guide
Quick Installation Guide
Quick Installation Guide
Quick Installation Guide
EAP110 Enterprise Access Point
ENGLISH
Copyright © 4IPNET, INC. All rights reserved.
2
System Overview
Connector Panel
EAP110 Connector Panel
1
5V
1A
Attach the power adapter here.
2
LAN(PoE)
Attach the Ethernet cable here for connecting to wired local network. This port supports
PoE as well which can be connected to a PSE (power sourcing equipment) as an
alternative power sourcing.
3
WES
Press to start running WES process.
WES Role
Master (Press for more than 3
seconds until the WLAN LED
blinks twice and then release)
Slave (Press once until the WLAN
LED starts blinking and then
release right away)
WES Start
WLAN LED BLINKING SLOWLY
WLAN LED BLINKING QUICKLY
WES Success
WLAN LED ON constantly for 5 seconds
WES Fail
WLAN LED OFF for 5 seconds
3
Reset
Press and hold the button for more than 10 seconds until WLAN LED OFF. WLAN ON
while reset is successful.
4
Antenna
Connector
Attach the antennas here. The system supports one RF interface with two SMA
connectors.