4IPNET HSG200 Quick Start Manual - Hardware Installation

Quick Installation Guide 

HSG200 802.11n/b/g Hotspot Gateway ENGLISH 

4 

Hardware Installation

Please follow the steps mentioned below to install the hardware of HSG200: 

1.  Place the HSG200 at a best location. 

The best location for HSG200 is usually at the center of your wireless network. 

2.  There are two ways to supply power over to HSG200. 

(a) 

Connect the DC power adapter to the HSG200 power socket on the front panel.   

Please only use the power adapter supplied with the HSG200 

package. Using a different power adapter may damage this 

system.  

(b) 

HSG200 is capable of receiving DC current via its WAN PoE port. Connect an 

IEEE 802.3af-compliant PSE device, e.g. a PoE-switch, to the WAN port of 

HSG200 with an Ethernet cable.

3.  Connect HSG200 to your outbound network device. 

Connect one end of the Ethernet cable to the WAN port of HSG200 on the front panel. 

Depending on the type of internet service provided by your ISP, connect the other end 

of the cable to the ATU-Router of an ADSL, a cable modem, a switch or a hub. The 

WAN LED indicator should be ON to indicate a proper connection.   

4.  Connect HSG200 to your network device. 

Connect one end of the Ethernet cable to the LAN1 port of HSG200 on the front 

panel. Connect the other end of the cable to a PC for configuring the system. The 

LAN1 LED indicator should be ON to indicate a proper connection. 

 Note: 

HSG200 has two virtual zones Private and Public which are mapped to 

LAN1(192.168.1.254) and LAN2(192.168.11.254) respectively.   

Now, the hardware installation is completed. 

To double verify the wired connection between HSG200 and your 

switch/router/hub, please check the LED status indication of these 

network devices. 

4Gon   www.4Gon.co.uk   info@4gon.co.uk   Tel: +44 (0)1245 808295   Fax: +44 (0)1245 808299