4Kam Air HDs Pro HD Manual - page 4
Camera Operation
Recording videos
1. Aim at what you want to record.
2. Press the ON/OFF button for 2 sec. to power on into standby mode, green led light .again press on/off button,start
recording. illuminate the blue LED and automatically start recording, the blue LED will flash .
3. The Laser pointer at the front of the camera will turn on for a more accurate adjustment of the target . The laser will stay
on for 10 sec. During recording, users can short press the ON/OFF button to turn on/off the laser pointer.
(Do Not look directly to the Laser Point or aim at other's eyes.)
4. Power Off: Press the ON/OFF button for 2 sec. and release.
Camera settings
1. Connect camera to PC
2. Find the setting.txt document under the new disk found
3. Change the UPDATE: Y to N to make the changes going into effect. The default is 1.
Function 0
1
2
3 Default
EV
6
0-12 Adjustable
AWB Auto
Daylight
Cloudy
Fluorescent auto
CTST
100
1-200 Adjustable
SAT
100
1-200 Adjustable
SHARPNESS
100
1-200 Adjustable
QUALITY High
Middle
Low
Middle
Audio Enable
Max
Mid
Low
Middle
LIGHT FREQ
60
50
50
RTC Display
OFF
ON
ON
LaserLed OFF
ON
ON
SensorRotateEnable OFF
ON
OFF
VideoSwitch 1080P
720P
1080P
NOTE: Users can choose 50HZ or 60HZ by this setting to avoid flickering in the video while shooting indoors, you need to
adjust this setting to match the frequency of light source.
LED Indicator
Function
Green LED Blue LED
Red LED
Laser Pointer
Power on
Stay on
Stay on for 5 sec.
Off
Quick flash for 10 times
Power off
Stay on for
1 sec. & go
off
Stay on for 1 sec. &
go off
Off
Quick flash for 5 sec.
Recording
Stay on
Flashes 1 time per 1
sec.
Off
Stay on for 3 times. & go off
Without TF card
or card is full
Quick flash
for 10
times
Flash for 10 times.
Off
Stay on for 5 times. & Standby
Low battery
Flash for 5
sec.
Flash for 5 sec.
Off
Stay on for 5 sec. & go off
Charging Stay
on
Off
On Off
Fully charged
Stay on
Off
Off
Off