5th-room 5RFWS1 Instruction Manual - page 7
7
P
F. TROUBLE SHOOTING
NO SOUND
-
Too much water retention inside the speaker grill. Turn the speaker over and gently shake it to let the
water drain out.
-
Ensure you have fresh alkaline batteries for both transmitter and receiver if the speaker’s and/or
transmitter’s battery charge is too low, sound distortion will be heard. Replace with new batteries.
-
Ensure the audio component is On and its volume is set to at least 50%.
-
The connected audio equipment is not playing. Start playing the equipment.
-
The volume of speaker is too low; adjust the volume to an appropriate level. Adjust your audio source
component volume to maximum.
DISTORTED
-
Too much water retention inside the speaker grill. Turn the speaker over and gently shake it to let
the water drain out.
-
Press the “Scan” button on the speaker to best match the frequency of the transmitter.
-
Change the position of the channel selector on the transmitter. You must then press the “Scan”
button on the speakers.
-
Battery capacity is too low. Replace with the new batteries.
-
Ensure the volume level of speakers is adjusted properly.
-
The speaker is too far from transmitter, move closer.
-
The input level of the audio signal is too low. Turn up the volume of the audio source equipment.
G. TECHNICAL SPECIFICATIONS
Transmission Mode
:
UHF stereo
Carrier Frequency
:
900 MHz
Operation Voltage
: Transmitter, 4 X “AA” size Alkaline batteries
(included) or DC 6V 300mA adaptor (included)
Speaker, 6 X “AA”
size Alkaline batteries
(included)
Frequency Response
:
40Hz – 12kHz
Distortion :
1.5%
S/N Ratio
:
65dB (typical)
Operation Distance
:
Up to 50 metres (150 feet)
Output Power
:
3W (Max)
WARNING: This device complies with AS/NZS CISPR 13:2004 and AS/AZS 22:2006 Australian
Standards Tests.
This is a Class A Product
This device may cause radio interference in some situations in which case the user is required
to take adequate measures when operating this device