6mmFlyRC F-14 Tomcat Instruction Manual - page 25
Battery mounted to fuselage
floor with a strip of Velcro
1/8" lite-ply spar box top,
bottom, and doublers
1/8" lite-ply servo tray
Wing Sweep Mechanism Detail
Hitec HS-81 MG servo
with 1/8" lite-ply servo arm
3/8" balsa spacer
Nosecone and canopy made
from laminated foam sheets
or foam block carved to shape
Copyright © 2005 All Rights Reserved
Designed and drawn by Steve Shumate
Span: 40.7"/24.7"
Wing area: 220 sq in
Weight: 20 - 23 oz RTF
Wing loading: 14 oz/sq ft
NOTES:
* All parts are made from 6mm Depron or BlueCore foam unless
otherwise indicated
* If using BlueCore, peel the plastic covering off both sides
of all fuselage parts (leave the skin on all wing and
empennage parts for strength)
* Recommended control deflections (all dimensions
measured at root trailing edge):
Tailerons (pitch): +/- 1.5" (-40% expo)
Tailerons (roll): +/- 1.75" (-40% expo)
Rudder: +/- 7/8" (-30% expo)
* Wing sweep to stabilator mixing is required to keep the
airplane trimmed as the wing sweeps. Set it up so
that swinging from full forward to full aft sweep provides
1/4" trailing edge up stabilator (about 5% mix rate)
* Rudder control is optional and provides better control
for aerobatics and low-speed high alpha flight
* Use a heat gun to gently form the foam in the fuselage
to the shapes shown
Sand forward fuselage/canopy
to contours shown
Fuselage Cross Section Detail
Vertical tails canted
5 deg outboard
If you enjoy these plans, please consider sending a small contribution
to the designer to show your appreciation for all the work that went
into developing them. Suggested contribution is $10 U.S., and can
be sent via PayPal to jetset44@verizon.net. Thanks for your support!
2
4
6
8
2
4
6
8
0
Scale in inches
RECOMMENDED POWER SYSTEM:
* For best results choose a power system that provides
20-25 oz static thrust and 45-50 mph pitch speed.
* Prototype used Himax 2015-4100 with 4.4:1 gearing, 9x6 APC
Slowflyer prop, 1320 mAh 11.1V lithium-polymer battery, and
Castle Creations Phoenix 10 speed control
Laminated 1/8" lite-ply spacer
Laminated 1/8" lite-ply tongue