6mmFlyRC F-4 Phantom II Instruction Manual - page 18
Elevator servo location
Control Horn Installation
The control horns that come with your
kit install by simply applying epoxy to
the spars and bottom and pressing into
place. The spars may need to be
trimmed to prevent them from poking
through the other side of the foam. The
control horns have several small holes
that must be lined up with the control
surface edge (see picture), either the
aileron or elevator.
Control horns
Holes lined up over butting edge of
aileron or elevator
Canopy Installation
See canopy installation guide in your
instruction CD. With the F-4, you will
be using 1 piece of depron (precut)
instead of the 2 indicated in the canopy
instruction guide.
Splitter Installation (Optional)
Your kit also comes with two 3mm
splitter pieces that can be attached by
inserting on end into each intake. These
are decorative pieces and in no way
affect the performance of your park jet.