7inova 7W211 Quick Installation Manual
Wireless-N WiFi Repeater 300Mbps
Model: 7W211
QUICK
INSTALLATION
GUIDE
LED indicators’ Status Description
WPS Button
Ethernet
Reset Button
WLAN LED
WPS LED
Ethernet LED
Power LED
Indicator
Name
Power Status Indicator
Wireless Status Indicator
WPS Status Indicator
Ethernet Status Indicator
Green On
Green slow blink
Green fast blink
Off
Constant On (Off after 5mins)
Green fast blink
Green fast blink
Green On
Get Powered
Wireless Function Launched
WPS Function Launched
Not use or have completed the connection
WPS pairs successfully
Data Transmission via Ethernet
Ethernet Connected
Data Transmission via wireless
Status
Description
REPEATER
CLIENT
WPS One Button Setup
Functions Introduction
Before you start to use this device, please check if there’s anything
missing in the package, and contact your dealer of purchase to claim for
missing items:
PACKAGE CONTENTS:
Cautions:
1. Disconnect the device in thunderstorms in case of lightning damage.
2. Keep far from heat source and ensure ventilation.
3. Keep waterproof in the storage, transportation and operating environment.
QIG
Quick
Installation
Guide
Ethernet Cable
WiFi Repeater
A P
Wireless Access Point
(AP: convert wired network to wireless network)
This Device can be used as a wireless AP, make your wired
network WiFi ready, your wireless devices can go internet
wirelessly via our repeater.
Client
(Client: convert wireless network to wired network)
Wired network devices (such as game console/computer), use
network cable connect the device through the CLIENT mode,
connect 2.4GHz wireless signal for Internet access.
Wireless Repeater
(Repeater: extend your existing wireless signal)
This Device connects to existing wireless network, and extends
wireless cover range.
Tips:
Your root-wireless device can be scanned by this device,
and its signal strength should be no less than “ ”
Plug this device into socket, Power light should be constant on. WiFi LED always blinks, means the device starts to work.
1
Press WPS button of root-wireless device for 2seconds,
launch WPS function. (Please refer to your rooted wireless
device’s user manual for its WPS button usage)
The device’s WPS LED should be constant on, then means WPS connect successfully.
(This WPS LED will turn off after 5 minutes)
2
4
In 2 minutes, press the WPS button of this device for 2seconds,
launch its WPS function. When WPS LED blinks, means
WPS is connecting.
3
ATTENTION: Above is only workable provided both of root-wireless device and this device have normally working WPS button. If
has no WPS button, please refer to “WiFi Repeater Web browser setup wizard”.
WPS
ADSL Router
Internet
Wireless Device
ADSL Router
Internet
Wireless Device
ADSL Router
Internet
Wired Device