909 A750 Instruction Manual - Ac Overload Cut Out
13
WARNING.
Prior to connecting any product to the generator,
check the rating label of the product. The generator is rated
at 650W so if the product being connected is higher than
650W, the protective cut out on the generator may operate
to prevent over load damage to the generator. The generator
will withstand short operation and spikes up to 720W.
It should also be very clearly understood that output voltage
fluctuations will occur when various loads are connected
and disconnected. It is best to always use a voltage or surge
protector with this generator.
It is NOT recommended to
connect any electronic equipment to the generator such
as computers, televisions, or stereo equipment. They
are very sensitive to the input supply fluctuations and
could be damaged if run off this generator. This warning
also includes caravans where electronic equipment is
incorporated as part of the wiring.
AC overload cut out
IMPORTANT:
Exceeding the rated capacity of your
generator can result in serious damage to your generator
and connected apparatus.
1. The AC 240V output has a circuit breaker to protect the
generator from over loading.
2. If the circuit breaker trips, unplug all electrical apparatus
from the generator.
3. Let the overload cut out switch cool down.
4. If it is an AC apparatus causing the overload push the AC
circuit breaker button (11).
5. When re connecting appliances, reduce the load to that
which previously overloaded the generator.
Periodic maintenance
Items
Remarks
Every 50hrs
or every
month
Every 150
hrs or every
month
Spark Plug Remove
Carbon
x
Air Filter
Cleaning
x
Fuel Filters Clean
x
Decarbon-
isation
Clean
x
Generator maintenance
Your generator should be kept clean and dry at all times.
The generator should not be stored or operated in environments
that includes excessive moisture, dust or any corrosive vapours.
If these substances are on the generator, clean with a cloth or
soft bristle brush. Do not use a garden hose or anything with
water pressure to clean the generator. Water may enter the
cooling air slots and could possibly damage the rotor, stator and
the internal windings of the generator head.
Storage
If you are going to store your generator for more than
30 days, use the following information as a guide to
prepare the generator for storage.
Never store generator with fuel in the tank indoors or
in enclosed, poorly ventilated areas, where fumes can
reach an open flame, spark or pilot light as on a furnace,
water heater, clothes dryer or other gas appliances.
Remove all fuel from the fuel tank.
Drain all fuel from the Carburetor bowl.
When storing the generator, ensure the generator has
fully cooled.