909 BM018 Instruction manual - Trouble Shooting
14
Trouble shooting
WARNING!
Turn the on/off switch to the off position and unplug the tool
from the power supply before performing trouble shooting procedures.
Trouble
Problem
Suggested remedy
Biscuit joiner
will not start
Power cord not plugged in
Ensure that the cord is connected to the power supply
Power fault, fuse or circuit breaker tripped
Check the power supply
Cord damaged
Use authorized service centre to repair or replace
Burned out switch
Use authorized service centre to repair or replace
Faulty motor
Use authorized service centre to repair or replace the motor
Blade does not
reach full speed
Extension cord too long or undersized
Use extension cord heavy enough to carry the current
Tool is overheating
Turn off the tool and let it cool down to room
temperature. Inspect and clean the ventilation slots
Biscuit does
not fit into slot
Incorrect biscuit being used
Check to see that the biscuit is the same size as
the slot cut. ie. use a #10 biscuit for a #10 slot.
Poor cutting
Accessory blunted
Replace with new biscuit joiner blade
Vibration or
abnormal noise
Loose parts
Check to see that all levers are secure including bevel
adjustment lever and height adjustment lever
Blade vibrating
Ensure that the blade flange is securely tightened
Moving parts excessively worn
Use authorized service centre to repair or replace